Philips AZ302 user manual Problem, No sound /power, CD skips tracks

Troubleshooting

If a fault occurs, first check the points listed below before taking the set for repair.

If you are unable to remedy a problem by following these hints, consult your dealer or service centre.

WARNING: Do not open the set as there is a risk of electric shock. Under no

	circumstances should you try to repair the set yourself, as this will
	invalidate the guarantee.
Problem		Note:
		Make sure the CD is not encoded with
–	Possible cause
		copyright protection technologies, as some
•	Remedy
		do not conform to the Compact Disc
No sound /power		standard.
–	Volume not adjusted	The CD skips tracks
•	Adjust the VOLUME	–	CD damaged or dirty
–	Power cord not securely connected
		•	Replace or clean CD
• Connect the AC power cord properly
		–	Program/shuffle is active
– Batteries dead/ incorrectly inserted
		•	Quit program/shuffle mode

•Insert (fresh) batteries correctly

– CD contains non-audio files	Note: A CD badly scratch or dirty may result in
	improper operation.

•Press ∞ , § once or more to skip to a CD audio track, instead of the data file.

Display does not function properly / No	Sound skips during MP3 playback
reaction to operation of any of the	–	MP3 file made at compression level exceeding
controls		320kbps
– Electrostatic discharge	•	Use a lower compression level to record CD
• Switch off and unplug the set. Reconnect after a		tracks into MP3 format
	–	Disc damaged or dirty
few seconds
	•	Replace or clean disc
--, Er or 01 indication

–No CD inserted

• Insert a CD

–CD badly scratched or dirty

•Replace/ clean CD, see Maintenance

– Laser lens steamed up

•Wait until lens has cleared

–CD-R/CD-RW is blank or not finalized

•Use a finalized CD-R/CD-RW or suitable CD Audio disc only