Troubleshooting
If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or service centre.
WARNING: Do not open the set as there is a risk of electric shock. Under no
|
| circumstances should you try to repair the set yourself, as this will | |
|
| invalidate the guarantee. | |
Problem |
| Note: | |
– | Possible cause |
| Make sure the CD is not encoded with copy- |
| right protection technologies, as some do not | ||
• | Remedy |
| |
| conform to the Compact Disc standard. |
No sound /power
– | Volume not adjusted |
| The CD skips tracks | |
| – | CD damaged or dirty | ||
• | Adjust the VOLUME |
| ||
| • | Replace or clean CD | ||
– | Power cord not securely connected |
| ||
| – | Program/shuffle is active | ||
• Connect the AC power cord properly |
| |||
| • | Quit program/shuffle mode | ||
– Batteries dead/ incorrectly inserted |
| |||
|
|
| ||
• | Insert (fresh) batteries correctly |
| Note: A CD badly scratch or dirty may result in | |
– | CD contains |
| improper operation. | |
• | Press ∞ , § once or more to skip to a CD audio |
|
|
|
| track, instead of the data file. |
| Sound skips during MP3 playback | |
|
|
| ||
|
|
| – MP3 file made at compression level exceeding | |
Display does not function properly / No |
|
| 320kbps | |
reaction to operation of any of the |
| • Use a lower compression level to record CD | ||
|
| tracks into MP3 format | ||
controls |
|
| ||
| – | Disc damaged or dirty | ||
– | Electrostatic discharge |
| ||
| • Replace or clean disc | |||
|
|
|
•Switch off and unplug the set. Reconnect after a few seconds
---, Er or no indication
–No CD inserted
• Insert a CD
–CD badly scratched or dirty
•Replace/ clean CD, see Maintenance
– Laser lens steamed up
•Wait until lens has cleared
–
•Use a finalized