User Manual BDL5231V/00

NOTE 3: “PIP”, “POP” and “SIDE BY SIDE”

The following table shows the combination of signal inputs under which the “PIP” and “POP” modes function. These modes do not function, however, when the screen size is “CUSTOM” or “REAL”.

 

 

 

 

 

SUB

 

 

 

 

 

HDMI

DVI-D

PC-A

CVI

VIDEO(S)

AV

 

 

HDMI

±

±

±

±

{

{

 

 

DVI-D

±

±

±

±

{

{

{: Supported

MAIN

PC-A

±

±

±

±

{

{

±: Not supported

CVI

±

±

±

±

{

{

 

 

VIDEO(S)

{

{

{

{

±

±

 

 

AV

{

{

{

{

±

±

 

Press the “PIP ON/OFF” buttons on the remote control to change between “PIP”, “POP” and “SIDE BY

SIDE” mode as shown in the diagram below.

PIP

POP

SIDE BY SIDE

SIDE BY SIDE

OFF

ASPECT

FULL

A B A

B A BA B A

“PIP”, “POP” mode resolution (Reference)

PIP SIZE

POP SIZE

SMALL

 

: 450 dots X 338 dots

 

MIDDLE

 

: 675 dots X 450 dots

 

LARGE

 

: 900 dots X 675 dots

 

 

 

 

: 450 dots X 338 dots

< Remote control numbering function >

By connecting multiple BDL5231V monitors using RS-232C cables, you can control any one monitor or all the monitors by one remote controller.

1.Assign arbitrary ID number to each of multi-connected BDL5231V monitors using MONITOR ID. ID numbers 1 to 26 are selectable.

It is recommended to assign sequential ID numbers from 1 and up.

2.The remote control mode of the first BDL5231V monitor is set to PRIMARY and those of the other monitors are set to

SECONDARY.

3.When you direct the remote controller at the remote control signal sensor of the PRIMARY monitor and press the DISPLAY button on the remote controller, the ID selection OSD appears at the upper left of the screen.

ID number of the currently viewed monitor

Select the ID number of the monitor you want to control using the +/- button on the remote controller.

The ID of the monitor you want to control is displayed at the upper left of its screen. By selecting ALL, you can control all the multi-connected monitors.

4.Direct the remote controller at the remote control signal sensor of the PRIMARY monitor. OSD appears on the monitor having the ID number you selected.

NOTE:

When the ID selection OSD is being displayed on the PRIMARY monitor, press the DISPLAY button on the remote controller again to cancel the ID selection OSD and then control the monitor you selected.

HINT:

If you set the remote control mode wrongly and remote control operation becomes unavailable, press any button on the control panel of the monitor to display the OSD screen and change the remote control mode using ADVANCED OPTION. By pressing

and holding down the DISPLAY button on the remote control for 5 seconds or longer, the remote control mode is initialized to

NORMAL.

41

Page 44
Image 44
Philips BDL5231V user manual B a B a, Remote control numbering function