Troubleshooting, Problem, Er or 01 indication

Troubleshooting

If a fault occurs, first check the points listed below before taking the set for repair.

If you are unable to remedy a problem by following these hints, consult your dealer or service centre.

WARNING: Do not open the set as there is a risk of electric shock. Under no

		circumstances should you try to repair the set yourself, as this will
		invalidate the guarantee.
Problem			Note:
–	Possible cause		Make sure the CD is not encoded with copy-
			right protection technologies, as some do not
•	Remedy
			conform to the Compact Disc standard.

–Volume not adjusted

•	Adjust the VOLUME	–	CD damaged or dirty
		•	Replace or clean CD
–	Power cord not securely connected
		– Program/shuffle is active
• Connect the AC power cord properly
		•	Exit program/shuffle mode
– Batteries dead/ incorrectly inserted

•	Insert (fresh) batteries correctly	Note: A CD badly scratch or dirty may result in
–	Headphones connected to the set	improper operation.

•Disconnect headphones.

– CD contains non-audio files

•Press ∞ , § once or more to skip to a CD audio track, instead of the data file.

Display does not function properly / No reaction to operation of any of the controls

–Electrostatic discharge

•Switch off and unplug the set. Reconnect after a few seconds

–No CD inserted

• Insert a CD

–CD badly scratched or dirty

•Replace/clean CD, see Maintenance

– Laser lens steamed up

•Wait until lens has cleared