6 Hooking Up the TV/VCR
ANT.
Hooking Up Your TV/VCR With a
Cable Signal or Outdoor Antenna
IN
OUT
ANT.
Connect an RF coaxial cable (75-
ohm, not supplied) to the OUT
Jack on the Cable Box and to the
ANT(enna) Jack on the TV/VCR.
Connect a Cable signal or an anten-
na to the ANT(enna) Jack.
Hooking Up Your TV/VCR With a
Cable Box
To view any channel, set the TV/VCR to the
Cable Box output channel (channel 03 or 04).
Then, select channels at the Cable Box.
1
Hook up your TV/VCR using one of the connections shown.
A.B.ANT.
Rod Antenna
Hooking Up Your TV/VCR With an
Indoor Antenna
To install a rod antenna (supplied), push the
stem of the antenna into the antenna hole on
the top of the TV/VCR. Connect the antenna
wire to the ANT(enna) Jack on the back of
the TV/VCR as shown. Extend the antenna
and adjust its length, direction, and angle for
the clearest picture.
C.Connect the Cable signal to the IN
Jack on the Cable Box.
CCZ092comb.QX33 4/5/99 6:05 PM Page 6