Philips CDR570/00 Recording, Manual recording, English, Preparing for manual recording

RECORDING

Manual recording

ERASE

FINALIZE

SCROLL

DISPLAY

SOURCE

REC TYPE

RECORD

1

2

3

4

5

6

PLAY/PAUSE

STOP

CDR

7

8

9

10 11 12

MINI AUDIO

13 14 15 16

ANALOG

CD

CD

RECORDER

RW

CANCEL

MENU/STORE

ON/OFF

REWIND

FFWD

OPEN/CLOSE

EASY JOG

Recordable

ENTER

3 With the recorder stopped, press REC TYPE three times to enter the Manual Record standby mode.

➜MANUAL starts to flash and the display shows REC MANUAL.

	REM	REC TIME TRACK			TOTAL REM TRACK TIME FADE		STEP
DIGITAL I				PROGRAM		MANUAL SYNC	SCAN
OPTICAL I			CD RW			SHUFFLE REPEAT TRACK ALL
ANALOG

English

Important:

-Recording from CD-changers should always be started in the RECORD DISC, RECORD TRACK or MAKE CD mode.

-Only make analog recordings when digital recording is not possible.

Preparing for manual recording

1 Make sure the disc is absolutely free of scratches and dust particles.

2 Press SOURCE repeatedly until (depending on the connection used):

➜DIGITAL I d, OPTICAL I p or ANALOG a lights up and DIGITAL 1, OPTICAL or ANALOG appears on the display.

	REM	REC TIME TRACK			TOTAL REM TRACK TIME FADE		STEP
DIGITAL I				PROGRAM		MANUAL SYNC	SCAN
OPTICAL I			CD RW			SHUFFLE REPEAT TRACK ALL
ANALOG

•When Auto Track is ON (default setting), track numbers will automatically be increased during recording.

•To switch off the Auto Track function you have to enter Menu mode.

If you wish to increase track numbers manually, press TRACK INCR(ement) on the remote control. For further instructions see Menu mode.

ON (AUTO): The track increments are automatically taken over from the digital source material or after 2.7 seconds silence during analog recording.

OFF (MANUAL): Track numbers can be incremented manually by pressing TRACK INCR(ement) on the remote control. (Minimum track length is 4 sec.) (This can also be done in Auto mode.)

• Track numbers cannot be changed after recording.

Note: Auto track works only with Consumer Sources with a digital output signal according to the IEC 958 (consumer part) audio standard.

•If CHECK INPUT message also flashes, the digital connection is incorrect.

4 Play the source first to set the optimal recording level on the CD recorder.

5 Rotate the EASY JOG/ENTER key until, on the Record/Play Level bar, all the blue segments are alight, but the red segments do not light continuously during the loudest passages.

➜Display shows _XX DB.

6 Stop the source.

Start manual recording

1 To start recording, press RECORD on the CD recorder and immediately start the source (from Stop-mode).

➜d lights continuously. The track number and recording time appear on the display.

•To record a 3-second silence at the start of a track, press PAUSE on the CD recorder before starting the source.

•To check the elapsed recording time, press DISPLAY on the CD recorder. (This can also be done during the recording.)

2 To stop recording, press STOP on the CD recorder.

➜ WAIT lights up and d goes out.

•If STOP was pressed within 3 seconds after RECORD, no recording will take place.

•To interrupt recording, press PAUSE on the CD recorder. d starts to flash. Resume at step 1.

After recording the display will show UPDATE for several seconds.

Note: With AUTO TRACK ON, the recorder will stop and go to REC STANDBY for 1 minute and then goes to stop mode automatically. Recordings from DAT, DCC or recordings made analogously will stop after 20 seconds silence. With AUTO TRACK OFF, the auto stop mode is disabled.

17