Register your product and get support at
CEM210 |
|
|
| 5 | |
1 |
|
|
| ||
a | b | c | d | ||
| |||||
|
|
|
| 5mm | |
| e | f | g | h |
2
EN Quick Start Guide
3
a
c
AMP
b
4
a b | a | a |
| c |
|
| d |
|
a bc | b | b |
d |
|
|
e f | c | c |
g hi |
| d |
| d |
5mm
Overview of parts 1
Check and identify the contents of your package: 1
2 Sleeve
3 Front panel
4Trim plate
5 Rubber cushion
6 Disassembly tools
7 Screws (4 pieces)
8 ISO connector
For cars without ISO connectors 3 4
Caution
Be sure to connect the black ground (earth)
ÀUVWOHDG
1 &RQQHFWWKHDQWHQQDDQGDPSOLÀHUDV illustrated, if applicable.
2Cut off the bigger end of the supplied stan- dard connector.
3Check the car’s wiring carefully and connect them to the supplied standard connector.
e RED Ignition key +12V DC $21ZKHQ&&
f %/8( Motor/electric antenna relay control lead/
$UHOD\FRQWUROPSOLÀHU lead
g %/$&. Ground
h Orange Illumination switch
i <(//2: To the +12V car battery |
which is energized at all |
2Remove the two screws on the top of the unit.
3Remove the mounting sleeve with the supplied disassembly tools.
4Ensure that car dashboard opening is within these measurements:
5Install the sleeve into the dashboard and
VOHHYHWKHÀ[WRRXWZDUGWDEVWKHEHQG
6Place the rubber cushion over the end of the bolt.
7 Slide the unit into the dashboard until you |
Listen to radio
1Press SOURCE repeatedly to select Radio.
2Press 3 or 4 to select band: [FM1], [FM2], [FM3], [AM1], or [AM2] .
3Press ∞ or § to tune to a radio station manually.
To search for a radio station automatically, press 
/
for 3 seconds.
ÀOHVDXGLR3OD\
1 Press | on the front panel to release the |
©2009 Koninklijke Philips Electronics N.V. All rights reserved. CEM210_98_UM_V1.0
hear a click sound. |
panel. |
Connect wires
Caution
Ensure that all loose leads are insulated with electrical tape.
For cars with ISO connectors 2 3
1Pull out the ISO connectors from car dashboard and connect them to the bigger
end of the supplied standard connector.
2Connect the other end of the supplied stan- dard connector to the unit.
3LODVDPSOLÀHUDQGDQWHQQDWKH&RQQHFW- lustrated, if applicable.You can connect the
725&WKURXJKDPSOLÀHUWKHWRDXGLRFDU$ VXSSOLHGQRW FDEOHV5&$
4 Connect the supplied standard connector to the unit.
1 Green/black /HIWVSHDNHU
strip (Rear)
2White/black VSHDNHU/HIW
| strip | (Front) |
3 | Gray/black | Right speaker |
| strip | (Front) |
|
|
|
4 | Purple/black | Right speaker |
| strip | (Rear) |
times |
Note
Check wire connection before you mount the unit into a car.
If preset radio stations are lost when the ignition key is turned OFF and then back ON, reconnect the red leads crosswise to the yellow ones.
Attach the front panel 5
1SODWHWULPWKH$WWDFK
2Insert the right side of the panel in the chassis until it is correctly engaged.
3Press the left side of the panel and point the left hole at the left pillar.
8Reconnect the negative terminal of the car battery.
Turn on
1Press z to turn on the unit.
To turn off the unit, press z for 3 seconds.
Set clock
1Press MENU/DISP for 3 seconds.
2Press 3 or 4 repeatedly to until the cur- rently time is displayed.
3Turn z clockwise to set hour.
4Press zFRQÀUPWR
5Turn z
2Insert a CD with the printed side facing up.
3Close the panel.
» Play starts automatically.
To pause CD play, press 1 
.
To resume CD play, press 1 
again.
Insert the USB device
1Open the cover marked 
on the front panel.
2 VRFNHW86%WKHLQWRGHYLFH86%WKH,QVHUW
»7KH XQLW VWDUWV SOD\LQJ IURP WKH 86% device automatically.
| Connector | Connect to |
1 | $17(11$ | $QWHQQD |
4Release the panel to engage the left side.
6Press zFRQÀUPWR
2 | 5(/,1(2875$5 | Rear right speaker |
3 | 5(/,1(287/$5 | Rear left speaker |
Mount in the dashboard 5
1If the car does not have an
negative terminal of the car battery.
If you disconnect the car battery in a car that has an
If the car battery is not disconnected, to avoid
View clock
1Press MENU/DISP repeatedly until the clock is displayed.
