8Product specifications
Note
•• Specifications and design are subject to change without notice.
Amplifier
•Total output power: 60W RMS (30% THD)
•Frequency response: 20
•
•Input sensitivity:
•AUX: 600 mV
•Music iLink: 250 mV
Audio
•S/PDIF Digital audio input:
•Coaxial: IEC
•Optical:TOSLINK
Main unit
•• Power supply:
•• Power consumption: 20 W
•• Standby power consumption: ≤ 0.5 W
•• Speaker impedance: 4 ohm woofer, 4 ohm tweeter
•• Speaker drivers: 25 x 120 mm (1 x 5") woofer, 38 mm (1.5") tweeter
•• Frequency response: 150
•• Dimensions (WxHxD): 708 x 47 x 65 mm
•• Weight: 1.03 kg
Subwoofer
•Impedance: 8 ohm
•Speaker drivers: 130 mm (5.25") woofer
•Frequency response: 20
•Dimensions (WxHxD): 165 x 240 x 295 mm
•Weight: 2.6 kg
•Cable length: 3 m
Remote control batteries
9 Troubleshooting
Warning
•• Risk of electric shock. Never remove the casing of the product.
To keep the warranty valid, never try to repair the product yourself.
If you have problems using this product, check the following points before you request service. If you still have a problem, get support at www.philips. com/support.
Main unit
SURR on the front panel blinks continuously.
•Your SoundBar does not support Dolby or DTS encoded audio. Make sure that you change the audio output of the TV or device to 'Standard' or 'PCM'.
Sound
No sound from SoundBar speakers.
•Make sure your TV or other devices’ output is set to PCM (see 'Connect audio from TV and other devices' on page 8).
•Connect the correct audio cable from your SoundBar to your TV or other devices.
•On your SoundBar remote control, press the Source buttons to select the correct audio input.
•Make sure that the SoundBar is not muted. Press VOL +/- to restore the sound (see 'Adjust the volume' on page 10).
Distorted sound or echo.
•If you play audio from the TV through the SoundBar, make sure that the TV is muted.
•1 x CR2025
12 EN
