Philips user manual Prepare the remote control, Turn DS9800W on, Txlfno\, RuÀuvwWlphXvh 

Open the battery compartment.

Turn DS9800W on

After proper power connection, the unit switches on automatically.

‡ Wait for successful boot-up of the unit.

»The boot-up takes about 35 seconds.

»During boot-up, the LED indicator on the back of the unit blinks green

TXLFNO\

»After boot-up, if no Wi-Fi connection has been set up for DS9800W, the LED indicator starts to blink green slowly.

‡ To switch the unit to standby mode, press .

‡ To switch the unit on from standby mode, pressagain.

Prepare the remote control

Caution

‡Risk of explosion! Keep batteries away from heat,

VXQVKLQHRUÀUH1HYHUGLVFDUGEDWWHULHVLQÀUH

)RUÀUVWWLPHXVH

1 Remove the protective tab to activate the remote control battery.

To replace the remote control battery:

1

2 Insert one CR2032 battery with correct polarity (+/-) as indicated.

3 Close the battery compartment.

Note

‡Before you press any function button on the remote

FRQWUROÀUVWVHOHFWWKHFRUUHFWVRXUFHZLWKWKHUHPRWH control instead of the main unit.

‡If you are not going to use the remote control for a long time, remove the battery.

‡Point the remote control directly at the IR sensor on the front of the main speaker for better reception.

EN 11