Philips DS9800W user manual Connect to your home Wi- Fi network for AirPlay

4Connect to your home Wi- Fi network for AirPlay

To connect DS9800W to your existing home Wi-Fi network, you need to apply your home Wi-Fi setting to DS9800W.

You can do this in two ways (depending on which type of Wi-Fi router you use):

‡ Automatically - if your Wi-Fi router is WPS (Wi-Fi Protected Setup)-enabled and supports PBC (Push Button Connection) (see 'Scenario 1: Connect to a WPS router' on page 12)

‡ Manually - if your Wi-Fi router does not support WPS (see 'Scenario 2: Connect to a non-WPS router' on page 13)

Once connected successfully, DS9800W will remember your home Wi-Fi settings.Then you can enjoy AirPlay whenever DS9800W is powered on and connected to your home Wi- Fi network automatically.

Before connection of DS9800W to you home Wi-Fi network, check the points below.

1 Make sure that your Wi-Fi router is powered on and working properly.

2 Make sure that DS9800W has been powered on and booted up successfully (see 'Turn DS9800W on' on page 11).

3 Identify the type of your Wi-Fi router (see the user manual of your Wi-Fi router for details).

Scenario 1: Connect to a WPS router

Note

‡Before you press any button on DS9800W, make sure that DS9800W has been booted up successfully (see 'Turn DS9800W on' on page 11).

1Press the WPS button on your home Wi-Fi router.

WPS

2 Shortly after step 1, press Wi-Fi SETUP on the back of the main speaker.

»The LED indicator blinks red, yellow and green alternately.

»Within 2 minutes, the LED indicator stops blinking and stays green, and the unit beeps.

»DS9800W is connected to your home Wi-Fi network successfully.

12EN