PREPARATION 19
Connecting the power cord
1Plug the female end of the supplied power cord into the Mains(AC) jack
on the rear of the player.
2Connect the other end of the cord to an AC outlet.
Note:
When the player is in the “STANDBY”mode, it is still consuming some
power.If you wish to disconnect your player completely from the power, unplug
the power cord from the AC outlet.
Caution:Only qualified service personnel should remove the
cover or attempt to service this device.
Remote control battery installation
Loading the batteries
1Open the battery compartment cover.
2Insert batteries as indicated inside the battery compartment.
3Close the cover.
Caution:Do not mix old and new batteries. Never mix
different types of batteries (standard,alkaline, etc.)
NTSC/PAL Settings
You can switch the NTSC/PAL setting of the DVD player to match the
video signal of your TV.This setting only affects the television’s on-screen
display that shows the stop and setup modes.You may select either
NTSC or PAL.To change the DVD player setting to PAL or NTSC,
follow the steps below.
1Unplug the DVD player from the mains.
2Press and hold 9and Kon the front of the DVD player.While holding 9
and K,plug in the mains.
3After PAL or NTSC appears on the display panel of the DVD player,
release 9and Kat the same time.The PAL or NTSC that appears on the
display panel indicates the current setting.
4To change the setting,press Kwithin three seconds.The new setting
(PAL or NTSC) will appear on the display panel.