4 Get started

Prepare the remote control

1Open the battery compartment.

2Insert two R03 or AAA batteries with correct polarity (+/-) as indicated.

3Close the battery compartment.

Caution

‡Remove batteries if they are exhausted or if the remote control is not to be used for a long time.

‡Do not mix batteries (old and new or carbon and alkaline, etc.).

‡Batteries contain chemical substances, so they should be disposed of properly.

Find the correct viewing channel

1Press to turn on this product.

2Turn on the TV and switch to the correct video-in channel. (Refer to the TV user manual on how to select the correct channel.)

Select menu display language

‡ The language options may vary from different regions.

1Press SETUP.

» [General Setup] menu is displayed.

2Select [OSD language], then press .

3 Press to select a language, then press OK.

Turn on progressive scan

Note

‡To use the progressive scan feature, you must connect a progressive scan TV with the component video jacks (see “Connect” > “Connect video cables” > “Option 1: Connect to the component video jacks” for details).

1Turn on the TV to the correct viewing channel for this product.

2Press SETUP.

3Press to select [Video Setup].

4Select [Progressive] > [On], then press OK. » A warning message is displayed.

5To proceed, select [Ok] and press OK. » The progressive setup is complete.

Note

‡If a blank/distorted screen is displayed, wait for 15 seconds for the auto recovery.

‡If no picture is displayed, turn off the progressive scan mode as follows:

1)Press to open the disc compartment.

2)Press the Numeric button ‘1’.

6Press SETUP to exit the menu.

7You can now turn on the progressive scan mode on the TV (see the TV user manual).

Note

‡During play, when the progressive scan mode is on for both this product and the TV, distorted picture may display. In this case, turn off the progressive scan feature on both this product and the TV.

8EN

Page 7
Image 7
Philips DVP3100/96 Get started, Prepare the remote control, Find the correct viewing channel, Select menu display language