•To return to the previous menu, press 
.
•To exit the menu, press SETUP. [Analogue Output]
Select an analogue setting based on the audio device that is connected through the analogue audio jack.
•[Stereo] - For stereo output.
•[LT/RT] - For surround sound output through two speakers.
[Digital Audio]
Select a digital setting based on the digital amplifier/receiver that is connected through the digital jack (coaxial/digital).
•[Digital Output] - Select a type of digital output.
•[Off] - Disable digital output.
•[All] - Support
•[PCM Only] - Downmix to two- channel audio format.
•[LPCM Output] - Select the LPCM (Linear Pulse Code Modulation) output sampling rate.
•[48kHz] - For discs recorded at sampling rate of 48 kHz.
•[96kHz] - For discs recorded at sampling rate of 96 kHz.
Note
•[LPCM Output] setting is only available if the [Digital Output] is set to [PCM Only].
•The higher the sampling rate, the better the sound quality.
[Volume]
Set the default volume level when you play a disc.
1. Press OK.
2. Press 
to set the volume.
3. Press OK to confirm and exit.
[Sound Mode]
Select a preset sound effect to enhance the audio output.
•[3D] - Select a virtual surround sound effect that is produced from the left and right audio channels.
•[Movie Mode] - Select a sound effect for movies.
•[Music Mode] - Select a sound effect for music.
[Night Mode]
Make loud sound level softer and soft sound level louder so that you can watch the DVD movies at a low volume, without disturbing others.
•[On] – Enjoy quiet viewing at night.
•[Off] – Enjoy surround sound with a full dynamic range.
Note
•Applicable only to Dolby Digital encoded DVD.
Video setup
1 Press SETUP.
»[General Setup] menu is displayed.
2 Press 
to select [Video Setup], then press 
.
3 Select an option, then press OK.
4 Select a setting, then press OK.
•To return to the previous menu, press 
.
•To exit the menu, press SETUP.
18EN
