Philips DVP3336X/94 Large, Below 120 Hz, Small Cannot produce low, Subwoofer is connected

4Select a setting, then press OK.

‡ To return to the previous menu, press .

‡ To exit the menu, press SETUP. [Analogue Output]

Select an analogue setting based on the audio device that is connected through the analogue audio jack.

‡ [Stereo] - For stereo output.

‡ [LT/RT] - For surround sound output through two speakers.

‡ [V SURR] - For analogue surround sound output from the main speaker.

‡ [Multi Channel] - For surround sound output through 5.1 channel receiver.

[Digital Audio]

Select a digital setting based on the digital

DPSOLÀHUUHFHLYHUWKDWLVFRQQHFWHGWKURXJK the digital jack (coaxial/digital).

‡ [Digital Output] - Select a type of digital output.

‡ [Off] - Disable digital output.

‡ [All] - Support multi-channel audio formats.

‡ [PCM Only] - Downmix to two- channel audio format.

‡ [LPCM Output] - Select the LPCM (Linear Pulse Code Modulation) output sampling rate.

‡ [48kHz] - For discs recorded at sampling rate of 48 kHz.

‡ [96kHz] - For discs recorded at sampling rate of 96 kHz.

Note

‡[LPCM Output] setting is only available if the [Digital Output] is set to [PCM Only].

‡The higher the sampling rate, the better the sound quality.

[Volume]

Set the default volume level when you play a disc.

1.Press OK.

2.Press to set the volume.

3.Press OKWRFRQÀUPDQGH[LW

[Sound Mode]

Select a preset sound effect to enhance the audio output.

‡ [3D] - Select a virtual surround sound effect that is produced from the left and right audio channels.

‡ [Movie Mode] - Select a sound effect for movies.

‡ [Music Mode] - Select a sound effect for music.

[Speaker Setup]

Optimizes surround output for the connected speakers system.

‡ [Front Speaker]

Option Description

[Large] Produces low frequency signal below 120 Hz.

[Small] Cannot produce low frequency signal below 120 Hz.

‡ [Centre Speaker] / [Rear Speaker]

Option	Description
[Large]	Produces low frequency signal
	below 120 Hz.
[Small]	Cannot produce low
	frequency signal below 120 Hz.
[Off]	No speaker is connected.
‡ [Subwoofer]
Option	Description
[On]	A subwoofer is connected.
[Off]	No subwoofer is
	connected.

‡ [Speakers Volume] – Sets the volume level of each speaker to get the ideal audio balance.

1Press OK.

2Select a speaker, then press to adjust the volume.

English

EN 21