2.Press Æ to enter the list.
3.Press ï or Î to select a connector.
4.Press Æ to enter the list.
5.Press ï or Î to select the device attached to the connector.
6.Press OK to select the device.
7.Repeat the procedure until all devices are correctly assigned to connectors.
8.Press MENU to exit.
7.4.2Assign the AUDIO IN mini-jack connector
If you connect audio from a PC to the AUDIO IN
1.Press MENU on the remote control and select TV menu > Installation > Connections > Audio In L/R.
Connections | AUDIO IN L/R |
|
|
... | None |
EXT 3 | HDMI 1 |
HDMI 1 | HDMI 2 |
HDMI 2 | HDMI 3 |
HDMI 3 |
|
Side |
|
AUDIO IN L/R |
|
|
|
2.Press Æ to enter the list.
3.Press ï or Î to select the HDMI connector used by the PC.
4.Press MENU to exit.
7.4.3 Assign a channel decoder
Decoders that decode digital channels can be connected to EXT 1 or EXT 2 (SCART). You have to assign the TV channel as a channel to be decoded.Then assign the connection where the decoder is connected.
1. | Press MENU on the remote control |
|
2. | and select TV menu > Installation > | ENglish |
Press Æ to enter the list. | ||
| Decoder > Channel. |
|
3. | Press ï or Î to select the channel to |
|
| decode. |
|
4. | Press Í and go back to select Status. |
|
5. | Press ï or Î to select the connector used |
|
| by the decoder. |
|
6. | Press MENU to exit. |
|
7.5Use Philips EasyLink
Your TV suppports Philips EasyLink, which enables
7.5.1 Enable or disable EasyLink
1.Press MENU on the remote control then select TV menu > Installation > Preferences > EasyLink.
2.Select On or Off.
7.5.2 Use one-touch play
After enabling EasyLink, press play on your device.The TV automatically switches to the correct source.
7.5.3 Use one-touch standby
Press and hold . STANDBY on the TV or device remote control for at least three seconds.The TV and all connected HDMI devices switch to standby.
