EnglishCONTROLS
Supplied Accessories:
1 x headphones AY3805
1 x AC/DC adapter AY3162 (not for all versions)
CONTROLS ( see figure 1)
1...........................display
2 | 2; | switches the player on, starts playback and pauses playback. |
3 ESP | selects between the battery powersave mode and | |
|
| Electronic Skip Protection (ESP). ESP prevents playback |
|
| interruptions caused by shocks. |
4 PROG | programs tracks and reviews the program. | |
5 MODE | selects playback options (e.g. SHUFFLE, REPEAT). | |
6 DBB | switches the bass enhancement on and off. This button also | |
|
| switches acoustic feedback (the beep) on/off when it is |
|
| pressed for more than 2 seconds |
7 | 9 | stops playback/clears programmed tracks/ switches off the |
|
| set. |
8 | ∞ /§ | skips and searches tracks backward/forward. |
| 3 /4 | MP3 only: skips forward/backward albums. |
9OPEN 2 .............opens the CD lid.
0p / LINE OUT....3.5mm headphone jack;
jack to connect the player to another audio input of an additional appliance.
!VOL
@ OFF | switches HOLD off. |
RESUME | stores the last position of a CD track played |
HOLD | locks all buttons. |
# 4.5V DC | jack for external power supply. |
POWER SUPPLY
Batteries (not included)
Inserting AA (LR6, UM3) batteries
1Open the battery compartment.
2Insert 2 x AA batteries as shown into the battery compartment.
3Close the battery compartment.
Helpful Hints:
– Old and new or different types of batteries should not be combined.
– Remove batteries if they are empty or if the player is not going to be used for a long time.
Battery indication
The approximate power level of your batteries is shown in the display. 
Battery full
Battery
Battery
Battery dead or empty.When the batteries are dead or empty, the symbol A flashes, rP bAtt is displayed, and the beep tone sounds repeatedly.
Batteries contain chemical substances, so they should be disposed of properly.
The type plate is located on the bottom of the set.
POWER SUPPLY
Power adapter (supplied or optionally available)
Only use AY3162 adapter (4.5V/450mA DC, positive pole to the center pin). Any other product may damage the player.
1 Make sure local voltage corresponds to the power adapter's voltage.
2Connect the power adapter to the 4.5V DC jack of the player and to the outlet.
Helpful Hints:
–Always disconnect the adapter when you are not using it.
GENERAL INFORMATION
CD player and CD handling
• Do not touch the lens A of the CD player.
• Do not expose the unit, batteries or CDs to humidi- ty, rain, sand or excessive heat (caused by heating equipment or direct sunlight).
• You can clean the CD player with soft, slightly dampened,
•To clean the CD, wipe it in a straight line from the center toward the edge using soft,
•The lens may cloud over when the unit is moved suddenly from cold to warm surroundings. In that case, playing a CD is not possible. Leave the CD player in a warm environment until the moisture has evaporated.
•Active mobile phones in the vicinity of the CD player may cause malfunctions.
•Avoid dropping the unit as this may cause damage.
GENERAL INFORMATION
ENVIRONMENTAL INFORMATION
•All redundant packing material has been omitted. We have done our utmost to make the packaging easily separable into two mono materials: cardboard (box) and polyethylene (bags, protective foam sheet).
•Your set consists of materials which can be recycled if disassembled by a spe- cialized company. Please observe the local regulations regarding the disposal of packing materials, dead batteries and old equipment.
The set complies with the
1.This device may not cause harmful interference, and
2.This device must accept any interference received, including interference that may cause undesired operation.
–Apparatus shall not be exposed to dripping or splashing.
–Do not place any sources of danger on the apparatus (e.g. liquid filled objects, lighted candles)
