18
English
3140 115 xxxxx
Programming the disc tracks
Programming tracks is possible when playback is
stopped. Up to 40 tracks can be stored in the
memory in any order.
1Load the desired discs on the disc tray (refer to
“Loading discs”).
2Press PROGRAM to start programming.
➜PROG starts flashing.
3Press CD or DISC 1/2/3 to select a disc.
4Press í or ë repeatedly to select the desired
track.
5Press PROGRAM to store the track.
●Repeat steps 3–5 to store other discs and
tracks.
6To end programming, press Ç once .
➜PROG stays and the programme mode
remains active.
➜The total number of tracks programmed and
the total playing time are displayed.
7To start programme play, press ÉÅ .
➜"PLAY PROGRAM" is displayed.
Notes:
– If the total playing time is more than "99:59"
or if one of the programmed tracks has a number
greater than 30, then "--:--" is displayed
instead of the total playing time.
– If you attempt to programme more than 40
tracks, "FULL" is displayed.
– If you press any of the CD DIRECT 1/2/3
buttons on the remote control, the system will play
the selected disc or track, and the stored
programme will be ignored temporarily. The PROG
symbol also will disappear temporarily from the
display. It will reappear when playback of the
selected disc ends.
– During programming, if no button is pressed
within 20 seconds, the system will exit the
programme mode automatically.
CD Operation
To review the programme
●Stop playback and press í or ë repeatedly.
●To exit review mode, press Ç.
Erasing the programme
●Press Ç once when playback is stopped or
twice during playback.
➜PROG disappears and "PROGRAM CLEARED"
is displayed.
Note:
– The programme will be erased when the system
is disconnected from the power supply or when the
disc tray is opened.
For Recording, please refer to “Tape
Operation/Recording”.