Philips FW-C50, FW-C70 manual 21RECORDING, View Clock, Clock Setting, tape deck 2 to tape deck

21RECORDING

• Recording will start automatically.

5Press STOP•OPEN on tape deck 1 and tape deck 2 to stop dubbing.

Notes:

– At the end of side A, flip the tapes to

side B and repeat the procedure.

CLOCK

MINI HIFI SYSTEM

	PROGRAM SHUFFLE			STEREO	C
	REPEAT TIMER REC			BACK
	NEWS T.A. AM MW FMLW			FRONT HSD	R
	60Hz	250Hz 500Hz 1KHz	2KHz 4KHz 8KHz	L
					PRO LOGIC	DOLBY B
				S	S
STANDBY						NR
ON						RDS
CLOCK/	CD1 • 2 • 3	FM • AM		VIDEO		NEWS!
TIMER			TAPE 1 • 2

–	Dubbing of tapes is only possible from
	tape deck 2 to tape deck 1.
–	To ensure good dubbing, use tapes of
	the same length.

Recording from other sources (only on tape deck 1)

PROG

UP

SOUND

DOWN

CD	TUNER	TAPE	AUX
		▲	PRESET ▲
SEARCH • TUNING	STOP • CLEAR PLAY PAUSE PREV		NEXT
	SOUND NAVIGATION		VOLUME
DIGITAL SOUND		DYNAMIC BASS
CONTROL		BOOST

1Load a blank tape into tape deck 1.

2Press CD, TUNER or AUX.

•Start playback of the selected source.

3 Press RECORD on tape deck 1 to start recording.

ªThe REC starts flashing.

4Press PAUSE to interrupt recording.

5Press STOP•OPEN on tape deck 1 to stop recording.

Note:

–During recording, it is not possible to listen to another sound source.

View Clock

You can view the clock (if it is set) if the system is in Standby mode or when any sound source is selected (CD,TUNER, etc.). The clock will be displayed for about seven seconds.

•Press CLOCK/TIMER briefly.

ª“PM 10:38 or 22:38 ” (the current time) will be displayed depending on whether you have selected 12- or 24-hour mode.

ª“--:--” will be displayed if the clock is not set.

Note:

–When the system goes into low power standby mode, the clock setting will not be displayed (for model FW-C70 only).

Clock Setting

The clock can be set in either 12- or 24-hour mode, e.g. “AM 12:00“ or “00:00“. Before setting the clock, you must be in the View Clock mode.

1Press CLOCK/TIMER to select clock mode.

2Press PROG (on the system only) to select 12- and 24- hour mode.

ªIf 12-hour mode is selected, “AM 12:00“ starts flashing.

ªIf 24-hour mode is selected, “00:00” starts flashing.

3Set the hour withʈ or ‡on the system.

4Set the minute withÊ’ or ‘on the system.

5Press CLOCK/TIMER again to store the setting.

ªThe clock starts.

pg 01-28/C50-C70/37-Eng 21 18/11/1999, 2:39 PM 3139 116 19441 (ENG)