Philips FWC527/37 warranty View Clock, Clock Setting, Timer Setting, Clock/Timer, English

	Clock/Timer
	English
IMPORTANT!	To exit without storing the setting

–When in Eco Power Standby mode, it is not possible to operate clock or timer function.

View Clock

The clock (if it is set) will be shown in Standby mode.

To view the clock in any source mode (CD or TUNER, for example)

●Press CLOCK•TIMER (or CLOCK on the remote control).

➜The clock will be displayed for a few seconds.

➜If the clock has not been set, "--:--" will be displayed.

Clock Setting

The clock can be set in either 12-hour or

24-hour mode ("AM 12:00" or "00:00" for example)

1Press CLOCK•TIMER twice.

2Press PROG on the system repeatedly to select clock mode.

➜If 12-hour mode is selected, "AM 12:00" will start flashing.

➜If 24-hour mode is selected, "00:00" will start flashing.

3Press à or á on the system repeatedly to set the hour.

4Press í or ë on the system repeatedly to set the minute.

5Press CLOCK•TIMER again to store the setting.

➜The clock will start working.

●Press Çon the system. Notes:

–The clock setting will be cancelled when the power cord is disconnected or if a power failure occurs.

–During clock setting, if no button is pressed within 90 seconds, the system will exit clock setting mode automatically.

Timer Setting

The system can switch on to CD,TUNER, or TAPE 2 mode automatically at a preset time, serving as an alarm to wake you up.

IMPORTANT!

–Before setting the timer, ensure that the clock is set correctly.

–The timer will always be switched on after it has been set.

–The timer will not start if a recording is in progress.

–The volume of the timer will increase gradually from the minimum level until it reaches the last tuned volume level.

1Press and hold CLOCK•TIMER for more than two seconds to select timer mode.

➜ "AM 12:00" or "00:00" or the last timer setting will start flashing.

➜ TIMER will start flashing.

➜ The selected source will be lighted while other available sources are flashing.

25