General Information
Refer to the type plate on the rear of the system for identification and supply ratings.
Supplied accessories (page 3 – P1)
ÐRemote control and two AA batteries.
ÐAM loop antenna
ÐFM wire antenna
ÐVideo cinch cable (yellow)
ÐAC power cord
Environmental information
All unnecessary packaging has been omitted. We have tried to make the packaging easy to separate into three materials: cardboard (box), polystyrene foam (buffer) and polyethylene (bags, protective foam sheet).
Your system consists of materials which can be recycled and reused if disassembled by a specialised company. Please observe the local regulations regarding the disposal of packaging materials, exhausted batteries and old equipment.
Care and safety information
(page 3 – P2)
Avoid high temperature, moisture, water and dust
ÐDo not expose the system, batteries or discs to humidity, rain, sand or excessive heat (caused by heating equipment or direct sunlight). Always keep the disc tray closed to avoid dust on the lens.
ÐNo objects filled with liquids, such as vases, shall be placed on the apparatus.
ÐNo naked flame sources, such as lighted candles, should be placed on the apparatus.
Avoid condensation problem
ÐThe lens may cloud over when the system is suddenly moved from cold to warm surroundings, making it impossible to play a disc. Leave the system in the warm environment until the moisture evaporates.
Do not block the vents
ÐIn a cabinet, allows about 10cm (4 inches) of free space all around the system for adequate ventilation.
Care of disc
ÐTo clean a CD, wipe it in a straight line from the centre towards the edge using a soft,
ÐWrite only on the printed side of a CDR(W) and only with a soft
ÐHandle the disc by its edge, do not touch the surface.
Care of the cabinet
ÐUse soft cloth slightly moistened with a mild detergent solution. Do not use a solution containing alcohol, spirits, ammonia or abrasives.
Finding a suitable location
ÐPlace the system on a flat, hard, and stable surface.
Built-in safety circuit
ÐUnder extreme conditions, this system may switch to standby mode automatically. If this happens, let the system cool down before reusing it.
Power saving
ÐThis system is designed to use less than 1W of electricity when switched to Eco Power standby. Disconnect the AC power cord from the power outlet when not in use.
E n g l i s h
9
