|
| ENGLISH 9 |
Problem | Possible cause | Solution |
| The | You have to perform the |
| not been completed. | process again (see chapter ‘IMPORTANT - |
|
| Cleaning and maintenance’). |
Dirty water and impurities come out of the soleplate.
Water flushes out of the soleplate.
The
The iron leaves a shine or an imprint on the garment.
Impurities or chemicals present in the water have deposited in the steam vents and/or soleplate.
You have accidentally started the
You have not pressed the
2 seconds until the appliance started beeping.
The surface to be ironed was uneven, for instance because you were ironing over a seam or a fold in the garment.
Perform the
Switch off the appliance.Then switch it back on again. Let the iron heat up until the ‘iron ready’ light lights up steadily.
See chapter ‘IMPORTANT - Cleaning and maintenance’.
Perfect Care is safe on all garments.
The shine or imprint is not permanent and will disappear when you wash the garment. Avoid ironing over seams or folds or you can place a cotton cloth over the area to be ironed to avoid imprints.
The ironing board cover becomes wet or water droplets come out of the soleplate.
Steam continues to come out after
I release the steam trigger.
There is a strong gush of steam when I release the steam trigger after placing the iron on the iron platform.
Steam is weak.
Steam has condensed on the ironing board cover after a long ironing session.
You may have an ironing board that is not designed to cope with the high steam rate of the steam generator.
Steam is generated in the soleplate. When you release the steam trigger, remaining water is transformed into steam.This is normal.
When the iron is tilted upwards, remaining water is collected and converted into strong steam.This is normal.
You do not press the steam trigger continuously.
Replace the ironing board cover if the foam material has worn out.You can also add an extra layer of felt material under the ironing board cover to prevent condensation on the ironing board.
Put an extra layer of felt material under the ironing board cover to prevent condensation on the ironing board.
Release the steam trigger 2 to 3 seconds before you place the iron back on the iron platform or ironing board.
Release the steam trigger 2 to 3 seconds before you place the iron back on the iron platform or ironing board.
Keep the steam trigger pressed continuously when you move the iron over the fabric.
4239_000_9295_3_DFU_Booklet_Simple_v2.indd 9
12/08/14 09:36
