Philips HR1744 manual in the correct position before you use the Blender, Save These Instructions

in the correct position before you use the Blender.

27.The blender base is intended for use only with this blender jar. Do not substitute any other blender jar.

28.This Blender has been equipped with an automatic safety cut-out which cuts off the power supply in case of an overload. In this case, the pin at the bottom of the Blender will pop out. If you push the pin back into the appliance, it will start again.

SAVE THESE

INSTRUCTIONS

SPECIAL INSTRUCTIONS

This Blender has a short cord to reduce the hazards of becoming entangled in or tripping over a longer cord. An extension cord may be used if the rating is equal to or greater than the rating of the Blender. Use an extension cord rated 13 amperes or greater. Care must be taken to arrange extension cord so that it will not drape over countertop or tabletop where it can be pulled on by children or tripped over unintentionally.

Operating the Blender and another appliance at the same time from the same electrical circuit could cause an electrical overload condition, which would blow the fuse or trip the circuit breaker.

SPECIAL POLARIZED PLUG

INSTRUCTIONS

This Philips Blender has a polarized plug for an

added safety feature (one blade is wider than the other). To reduce the risk of electrical shock:

•Plug will fit into polarized outlet only one way.

•If plug does not properly fit outlet at first, reverse it.

•If plug still does not fit, contact a qualified electrician.

DO NOT ATTEMPT TO DEFEAT THIS SAFETY FEATURE