SETUPS

EasyLink (HDMI CEC)

home A “Settings” A

“Advanced

A “Others” A

“EasyLink

 

Setup”

 

(HDMI CEC)”

This unit supports Philips EasyLink, which enables your TV (limited to PHILIPS brand EasyLink TV) to act in conjunction with this unit, or vice versa. Compliant TV must be connected to the HDMI OUT jack.

When “EasyLink (HDMI CEC)” setting is set to “On”, functions listed below will be available.

One Touch Play

When the operations with following buttons of the remote control of this unit are performed, the TV will automatically be turned on and switched to the appropriate input channel.

Buttons for one touch play:

-[B (play)], [S(previous)], [T(next)],

[the Number buttons], [ (home)], [INFO ], or

[SOURCE]

-[TOP MENU], or [DISC MENU / POP-UP MENU] (when a disc is inserted in the unit)

Standby

When you press and hold [Q(standby/on)] for 2 seconds, it turns off the power of the TV first and then turns off the power of this unit also.

System Information

Get & Set Menu Language

The unit recognizes the OSD language set for the TV and automatically sets the same language as the player menu language (OSD menu language) for this unit. Refer to the “Player Menu” on page 38 for available languages.

•This feature is available only when “Auto” is selected in the “Player Menu” in the settings menu.

Note

•For external input mode, “One Touch Play” is not available.

Network Connection

Set up the network connection settings in order to use BD-Liveor network upgrade function.

Connection Test

 

“Advanced

“Network

 

“Connection

home A “Settings” A

Setup”

A“Others” A Connection”

A

Test”

After you made IP address / DNS settings or when a LAN cable is connected, always perform the connection test to check if the connection is correctly made.

1)Use [K / L] to select “Settings” in the home menu, then press [OK].

2)Use [K / L] to select “Advanced Setup”, then press [OK].

3)Use [K / L] to select “Others”, then press [OK].

4)Use [K / L] to select “Network Connection”, then press [OK].

5)Use [K / L] to select “Connection Test”, then press [OK].

Connection test will start automatically and the test result will appear right after the connection test finishes.

•“Testing...” : The test is in progress.

•“Pass” : Connection test is successfully completed.

•“Fail” : Connection test failed. Check the connection

settings.

Press [OK] to go to the list of network status confirmation screen.

IP Address

xxx.xxx.xxx.xxx

Subnet Mask

xxx.xxx.xxx.xxx

Default Gateway

xxx.xxx.xxx.xxx

Primary DNS

xxx.xxx.xxx.xxx

Secondary DNS

xxx.xxx.xxx.xxx

 

then press 'OK'.

 

 

 

 

6)Press [OK] to go back to the previous screen, or press [ (home)] to go back to the home menu.

Note

•If the connection test passes, you are ready to use BD-Liveor network upgrade function using the Internet without making any extra settings.

•If the connection test fails, you may need to change the MAC address settings on your router. You can check the MAC address of this unit on “Network Status” screen (refer to page 51).

•When connecting this unit directly to a modem for the first time or connecting it to a modem which was previously connected to any other network device(e.g. a router, PC, etc.), you may have to power cycle the modem to reset the settings on the modem.

48 EN