English
Troubleshooting
WARNING
Under no circumstances should you try to repair the system yourself, as this will invalidate the warranty. Do not open the system as there is a risk of electric shock.
If a fault occurs, fi rst check the points listed below before taking the system for repair. If you are unable to solve a problem by following these instructions, consult your dealer or Philips for help.
Problem (General) |
| Solution |
|
| |
No power. | – | Check if the AC power cord is properly connected. |
| – | Press the 2(STANDBY ON) on the front of the |
|
| DVD system to turn on the power. |
No picture. | – | Refer to your TV’s manual for correct Video In |
|
| channel selection. Change the TV channel until you |
|
| see the DVD screen. |
| – | Press the DISC button to select disc mode. |
Completely distorted picture | – | If this happens when you are changing the setting of the |
or black/white picture. |
| ‘TV TYPE’, wait for 15 seconds for the auto recovery. |
| – | Check the video connection. |
| – | Sometimes a small amount of picture distortion may |
|
| appear. This is not a malfunction. |
| – | Clean the disc. |
No sound or distorted sound. | – | Adjust the volume. |
| – | Check the speaker connections and settings. |
| – | Make sure that the audio cables are connected and |
|
| press the SOURCE button to select the correct input |
|
| source (for example, TV or AUX/DI) to choose the |
|
| device that you want to hear through the DVD |
|
| system. |
There is no sound from the | – | Make sure that the centre and rear speakers are |
centre and rear speakers. |
| connected correctly. |
| – | Press the SURR. button to select a correct surround |
|
| sound setting. |
| – Make sure that the source you are playing is recorded or | |
|
| broadcast in surround sound (DTS, Dolby Digital, etc.). |
The remote control does not | – | Select the source you want to play (for example, |
function properly. |
| DISC or TUNER) before pressing the function button |
|
| (X, ./ >). |
| – | Reduce the distance between the remote control and |
|
| the system. |
| – | Replace the batteries with new ones. |
| – Point the remote control directly toward the IR sensor. | |
| – | Check that the batteries are loaded correctly. |
|
|
|
40