Philips LC 6281, LC 6285 Adjusting the focus and size of the image, Adjusting the vertical angle of the projector, Keystone correction

6To switch off the mains supply completely,disconnect the mains lead.

– Save energy! Please put the projector in the Power/Standby position if you are not going to use the

projector for more than 15 minutes.

– If SmartSave is enabled, the projector will switch to StandBy after the selected time.

If SmartSave is not enabled,the projector will not switch to StandBy.

This setting can be changed in the ‘Set up’menu

– Before disconnecting the mains lead,make sure that the cooling fan has stopped (about 3 minutes

after the projector has been switched to Power/Standby).

• Use the Zoom ring (LC6285 only) to adjust the size of the image.

• Use the Focus ring to adjust the focus of the image.

To raise:

• Keep knob A pressed and lift to raise the projector.

– The Height/Level Adjuster B will come out.

3Use the horizontal adjuster C to fine-tune the display angle.

To lower:

• Keep knob A pressed and gently lower the projector.

• Use the Focus Ring and Zoom Ring to readjust the focus and size of the image.

3Use the horizontal adjuster C to fine-tune the display angle.

If projector and screen are not properly placed, the picture will be distorted, producing a

keystoned image (picture top width larger than picture bottom width or vice versa/picture left

side width larger than picture right side width or vice versa).When a keystoned image occurs

the image ratio (4:3, 16:9) will still be guaranteed.This is especially important when the projector

is being used together with an ‘intelligent whiteboard’.

‘Keystone correction’ allows you to correct picture distortion of the vertical and horizontal

(horizontal is only for LC 6285) keystone type by internal scaling.

Vertical keystone correction on LC 6281

• Use Keystone to widen the upper part of the image.

• Use Keystone to widen the lower part the image.

– The keystone slider appears on the screen.

• This correction function also is accessible through the ‘Keystone’option in the ‘Set up’ menu

of the On Screen Display (OSD) menu.

Adjusting the focus and

size of the image

Adjusting the vertical angle

of the projector

Keystone correction

Philips Home Cinema Projector 17 English User guide LC 6281 / LC 6285

3. Set up

VOLUME +

VOLUME -

SOURCE

PICTURE SIZE -PICTURE SIZE +

VOLUME +

VOLUME -

SOURCE

PICTURE SIZE -PICTURE SIZE +

ANDBY/ON

Focus ring

Zoom ring

ANDBY/ON

STANDBY/ON

XP LC6281/6285 EVA English 01-08-2003 17:51 Pagina 17