CD Operation
2To resume normal playback, press REPEAT until "REPEAT OFF" is displayed.
➜ REP is shown, except for REPEAT OFF mode.
Notes:
–During program play mode, it is not possible to repeat playback the current disc (Repeat Disc mode).
–Pressing theÇ button will cancel all repeat modes.
Programming the disc tracks
Programming tracks is possible when playback is stopped. Up to 99 tracks can be stored in the memory in any order.
1Load the desired discs on the disc tray (refer to “Loading discs”).
2Press CD 1/2/3 to select a disc.
3Press PROG to start programming. ➜ PROG starts flashing.
4Press í or ë repeatedly (or numeric keys
●For MP3 disc, press ALBUM
5Press PROG to store the track.
●Repeat steps
6To end programming, press Ç once .
➜PROG stays and the program mode remains active.
➜The total number of tracks programmed and the total playing time are displayed.
➜For MP3 disc, total playing time will not be shown.
Notes:
–It is not possible to create a program with MP3 tracks from multiple CDs, or combined with normal audio tracks.
–If the total playing time is more than "99:59" then
–If you attempt to program more than 99 tracks, "FULL" is displayed.
–During programming, if no button is pressed within 20 seconds, the system will exit the Program mode automatically.
To review the program
●Stop playback and press í or ë repeatedly.
●To exit review mode, press Ç.
Erasing the program
●Press Ç once when playback is stopped or twice during playback.
➜ PROG disappears and "PROGRAM CLEARED" is displayed.
Note:
–The program will be erased when the system is disconnected from the power supply or when the disc tray is opened.
For Recording, please refer to “Tape Operation/Recording”.
E n g l i s h
7To start program play, pressÉÅ. ➜ "PLAY PROGRAM" is displayed.
19
pg | 19 | 4/17/02, 12:55 PM 3139 115 21402 |
