GENERAL INFORMATION
Supplied Accessories
-2 speaker boxes
-remote control with batteries
-AM/MW frame aerial
-FM aerial wire
General maintenance
•Do not expose the set, batteries, CDs or cassettes to humidity, rain, sand or excessive heat caused by heating equipment or direct sunlight.
•To clean the set, use a soft, slightly dampened chamois leather. Do not use any cleaning agents containing alcohol, ammonia, benzene or abrasives as these may harm the housing.
Environmental information
All unnecessary packaging material has been omitted. We have done our utmost to make the packaging easy to sepa- rate into three
Your set consists of materials which can be recycled if dis- assembled by a specialized company. Please observe the
local regulations regarding the disposal of packing materials, exhausted batteries and old equipment.
MC 118 / 22 page 5
POWER SUPPLY
2 1
Batteries for the remote control
•Open the battery compartment and insert two batteries, type AA, R06 or UM3 (preferably alkaline) with the correct polarity as indicated by the + and – symbols inside the compartment.
Important! Remove the batteries if they are flat or if the unit is not to be used for a long time.
Batteries contain chemical substances, so they should be disposed of properly.
Speaker connections
The speaker terminals are
–Connect the unmarked wire to the red terminal and the marked black wire to the black terminal.
•When headphones are inserted into the headphone socket the speakers are disconnected.
| speaker | |
| 8 Ω | |
AM | + | |
RIGHT | ||
aerial | ||
– | ||
| ||
| – | |
| LEFT | |
| + |
English |
Mains |
1Check if the mains voltage, as shown on the type plate located on the back of the set, corresponds to your local mains voltage. If it does not, consult your dealer or service centre.
2If your set is equipped with a voltage selector, adjust the selector so that it matches with the local mains.
3Connect the mains lead to the wall socket and the set is now ready for use.
4To disconnect the set from the mains completely, remove the plug from the wall socket.
For users in the UK, please follow the instructions on page 2.
POWER-SAVING AUTOMATIC STANDBY
As a
Safety information
•Place the set on a hard and flat surface so that the system does not tilt. Make sure there is adequate ventilation to prevent the system from overheating.
•The mechanical parts of the set contain
This set complies with the radio interference requi- rements of the EU.
5