Radio Reception
English |
Tuning to radio stations
1Press SOURCE to select TUNER. ➜ TUNER is displayed briefly.
2Press BAND (or TUNER on the remote control) once or more to select your waveband (FM/ MW).
2Press PROGRAM for more than 2 seconds to activate programming.
➜ AUTO is displayed and available stations are programmed in order of waveband reception strength: RDS, FM followed by MW. The last preset automatically stored will then be played.
Manual programming
1Tune to your desired station (see “Tuning to radio stations”).
2Press PROGRAM to activate programming.
3Press PRESET ¡ or ™ to allocate a number from 1 to 40 to this station.
4Press PROGRAM again to confirm the setting. ➜ The preset number and the frequency of the preset station are shown.
5Repeat the above four steps to store other stations.
●You can override a preset station by storing another frequency in its place.
3 | Press and hold TUNE à or á. | Tuning to preset radio stations |
| ||
| ➜ The radio automatically tunes to a station | ● Press PRESET ¡ or ™ until the desired preset |
| with sufficient reception. Display indication during | station is displayed. |
| automatic tuning: SEARCH. |
|
4 | Repeat step 3 if necessary until you find the |
|
| desired station. |
|
●To tune to a weak station, press TUNE à or á briefly and repeatedly until you have found
optimal reception.
Programming radio stations
You can store up to a total of 40 radio stations in the memory.
Automatic programming
Automatic programming will start with a chosen preset number. From this preset number upwards, former programmed radio stations will be overridden.The system will only program stations which are not in the memory already.
1Press PRESET ¡ or ™ to select the preset number where programming should start.
Note:
– If no preset number is selected, default is preset
(1) and all your presets will be overridden.
14