Preparations, Setting the clock | Philips MCD295/05 specs

Preparations

English

IMPORTANT!

–Make sure to complete the preparation procedures before operating the system.

Step 1: Inserting batteries into the remote control

1Open the battery compartment.

2Place two batteries (Type R06 or AA) in the compartment with the correct polarity as indicated by “+” and “–” symbols.

3Close the cover.

Using the remote control to operate the

system

1Point the remote control directly at the remote sensor (iR) on the front panel.

2Select the source you wish to control by pressing one of the

source select buttons on the remote control (for example DISC,TUNER).

3 Then select the desired function (for example 2;, í, ë).

CAUTION!

–Remove batteries if they are exhausted or will not be used for a long time.

–Do not use old and new or different types of batteries in combination.

–Batteries contain chemical substances, so they should be disposed of properly.

Step 2: Setting the clock

1Go to Standby mode.

2Press and hold CLOCK/RDS on the front panel.

➜ “SET CLOCK” is displayed briefly.Then, the hour digits flash on the display screen.

3Turn the VOLUME control on the front panel or press VOLUME +/- on the remote to set the hours.

4Press CLOCK/RDS again.

➜ The minute digits flash on the display screen.

5Turn the VOLUME control on the front panel or press VOLUME +/- on the remote to set the minutes.

6Press CLOCK/RDS to confirm the clock setting.

Notes:

–This system only supports 24-hour mode.

–The clock setting will be erased when the system is disconnected from the power supply.

–The system will exit clock setting mode if no button is pressed within 30 seconds.

18

Image 18

Philips MCD295/05 user manual Preparations, Inserting batteries into the remote control, Setting the clock

Contents

DVD Micro Theatre Mains plug How to connect a plugImportant notes for users in the U.K Copyright in the U.KPage Page Manufactured under license from Dolby Laboratories Language Code Contents Radio Reception Clock/TimerSystem Menu Options Tape Operation/Recording General Information FeaturesSupplied accessories Discs for playback General Information/Maintenance Care and safety informationEnvironmental information Place the player on a flat, hard, stable surface Cleaning the head and the tape pathsFinding a suitable location Demagnetising the head Connections Placing speakersType plate is located at the rear of the system Using Video In jack Cvbs Connecting speakersConnecting TV Antenna connection Using S-Video In jack Using an accessory RF modulator Connecting the power cord Optional Connecting additional equipment Controls on the remote control ControlsControls on the system $ Repeat § Timer@ PLAY/PAUSE Subtitle Using the remote control to operate System Inserting batteries into the remote controlSetting the clock Preparations Ntsc Setting video preferenceSystem Menu PAL Audio Lang DVD only Setting language preferenceTo exit the menu Subtitle Lang DVD only Volume control Switching the system to Eco Power Standby modePower-saving automatic standby Basic Functions Playing discs Using the disc menuDisc Operations Basic playback controls REP TitleOFF REP ALL Special disc features DVD/VCD/CD/MP3/WMA General operation Playing MP3/WMA/JPEG DiscPlaying MP3/WMA disc Playback selection Special Jpeg features Playing a DivX discPLAY/PAUSEÉÅ System Menu Options Basic operations KID Safe DefaultRating Adult Contrast Divxr VOD registration codeBrightness HUE Downmix Night ModeDigital OUT 3D Processing Radio Reception Tuning to radio stationsTuning to preset radio stations Programming radio stations Setting the RDS clock Scrolling through different RDS information Tape Operation/Recording Tape playbackGeneral information on recording Synchro start CD recording When recording is in progressPreparation for recording One touch recording Sleep timer setting Clock settingTimer setting See Preparations- Setting the clock Specifications Troubleshooting English ProblemSolution Check if the stripped speaker wire is clamped Glossary