20
English
IMPORTANT!
–Make sure to complete the
preparation procedures before operating
the system.
Step 1: Inserting batteries into
the remote control
1Open the battery compartment.
2Place two batteries (Type R06 or AA) in the
compartment with the correct polarity as
indicated by “+” and “–” symbols.
3Close the cover.
Using the remote control to operate the
system
1Point the remote control directly
at the remote sensor (iR) on the
front panel.
2Select the source you wish to
control by pressing one of the
source select buttons on the
remote control (for example
DISC, TUNER).
3Then select the desired function
(for example 2;, í, ë).
CAUTION!
–Remove batteries if they are
exhausted or will not be used for a long
time.
–Do not use old and new or different
types of batteries in combination.
–Batteries contain chemical substances,
so they should be disposed of properly.
Step 2: Setting the clock
1Go to Standby mode.
2Press and hold CLOCK SET on the front
panel.
➜“SET CLOCK” is displayed briefly. Then, the
hour digits flash on the display screen.
3Turn the VOLUME control on the front panel
or press VOL +/- on the remote to set the
hours.
4Press CLOCK SET again.
➜The minute digits flash on the display screen.
5Turn the VOLUME control on the front panel
or press VOL +/- on the remote to set the
minutes.
6Press CLOCK SET to confirm the clock
setting.
Notes:
–This system only supports 24-hour mode.
– The cloc k setting will be erased when the system
is disconnected from the power supply.
–The system will exit clock setting mode if no
button is pressed within 30 seconds.
T
PRESET
Preparations
pg001-pg04£∞_MCD515-93-Eng 2006.4.26, 10:0320