36
English
Clock/Timer

Clock setting

See "Preparations-Step 2: Setting the clock".

Timer setting

●The system can be used as an alarm clock,
whereby the last selected source is switched on
at a set time (one time operation). The clock
time needs to be set first before the timer can
be used.
1In standby mode, press and hold TIMER on the
remote for more than three seconds.
➜"SET TIMER" is displayed briefly. Then, the
hour digits flash on the display panel.
2Turn the VOLUME control on the front panel
or press VOL +/- on the remote to set the
hours and press TIMER on the remote to
confirm.
➜The minute digits flash on the display panel.
3Turn the VOLUME control on the front panel
or press VOL +/- on the remote to set the
minutes and press TIMER on the remote to
confirm.
➜"ON" or "OFF" flashes.
4Turn the VOLUME control on the front panel
or press VOL +/- on the remote to activate or
deactivate the timer and press TIMER on the
remote to complete the setting.
➜Display shows if activated, and disappears
if deactivated.

Sleep timer setting

The sleep timer enables the system to switch off
by itself after a set period of time.
1Press SLEEP on the remote control repeatedly
to select a preset time.
➜The selections are as follows (time in
minutes):
0FF™010 ™ 020 ™ 030 ™ 040 ™ 050 ™
060 ™070 ™ 080 ™ 090™ 0FF
➜"SLEEP XX" is displayed. "XX" is the time in
minutes.
2When you reach the desired length of time, stop
pressing the SLEEP button.
To deactivate the sleep timer
●Press SLEEP repeatedly until "0FF" is displayed,
or press STANDBY ON y.
TUNING
PRESET
DSC
PROGRAMMODEANGLE A-B
IS
pg001-pg04£∞_MCD515-93-Eng 2006.4.26, 10:0336