36
English

Radio Reception

Tuning to radio stations
1Press ECO POWER/STANDBY-ON B (B
on the remote) to switch on the last selected
source.
2Press SOURCE (TUNER on the remote) to
select TUNER mode.
3Press TUNER on the remote again to select
the desired band: FM or AM.
4Press and hold ¡ / (CH +/- ¡ / on the
remote) until the frequency indication starts to
change, then release.
The system automatically tunes to the next
strong radio station.
To tune to a weak station, press ¡ / (CH +/-
à / á on the remote) briefly and repeatedly
until an optimal reception is found.
5Repeat Step 4 if necessary until you find the
desired radio station.
Presetting radio stations
You can preset up to 40 stations (20 in each
band) regardless of the reception.
Automatic progamming
Press PROG on the remote for more than two
seconds to activate programming.
All available stations are programmed.
Manual progamming
1Tune to your desired radio station (refer to
“Tuning to radio stations”).
2Press PROG on the remote.
PROGicon flashes.
3Press PRESET+ or PRESET-/9 (or CH +/-
(¡ / ) on the remote) to select the desired
preset number.
If “PROGicon goes off before you select the
desired preset number, press PROG on the
remote.
4Press PROG on the remote again to store the
radio station.
Repeat steps 1-4 to store other radio stations.

Other Functions

Listening to preset radio stations
In tuner mode, press PRESET+ or PRESET-/9
(or CH +/- (¡ / ) on the remote) to select
the desired preset number.
The preset number, radio frequency, and
waveband are displayed.

Setting the clock

1In Standby mode, press and hold CLOCKon
the remote until the time flashes on the display.
CLOCK SETis displayed briefly. Then, the
hour digits flash on the display screen.
2Tur n VOLUME -/+ clockwise or anticlockwise
or press VOLUME +/- on the remote to set
the hours.
3Press CLOCK to confirm.
The minute digits flash on the display screen.
4Tur n VOLUME -/+ clockwise or anticlockwise
or press VOLUME +/- on the remote to set
the minutes.
5Press CLOCK again to confirm the clock
setting.
Notes:
This system only supports 12-hour mode.
The clock setting will be erased when the
system is disconnected from the power supply.
The system will exit clock setting mode if no
button is pressed within 30 seconds.

Setting sleep/wake-up timer

Sleep timer setting
In power-on mode, the sleep setting enables
the system to switch to standby mode
automatically at a preset time.
1In power-on mode, press SLEEP/TIMER on
the remote repeatedly to select a preset time.
The selections are as follows (time in
minutes):
00 10 20 30 40 50 60 70
80 90 00
pg 001-041_MCD718_37 2006.4.13, 17:5236