Philips MCM149 Basic Functions, Switching the system on, Power-savingautomatic standby, English

Basic Functions

English

STANDBY-ON	M I C RO S YS T E M M C M 1 4 9
iR	CD/CD-R/CD-RW COMPATIBLE

SOURCE

VOL

TUNING MODE PROG

ALBUM/PRESET

VOL

DBB

IMPORTANT:

Before you operate the system, complete the preparation procedures.

Plug and Play (for tuner installlation)

Plug and Play allows you to store all available radio stations automatically.

First time setup/power up

To exit without storing the Plug and Play

●Press 9 on the system.

➜ If you do not complete the Plug and Play installation, the function will be restarted when you next turn on the main supply again.

Note:

–During Plug and Play, if no button is pressed within 15 seconds, the system will exit Plug and Play mode.

Switching the system on

●Press STANDBY-ON 2 or SOURCE

(POWER, DISC, TAPE, TUN, or AUX on the remote control).

➜ The system will switch to the last selected source.

To switch the system to standby mode

●Press STANDBY-ON2 on the system (or POWER on the remote control).

Power-saving automatic standby

1When you turn on the main supply, "AUTO INSTALL - PLEASE PRESS PLAY / STOP CANCEL" is displayed.

2Press ÉÅ on the system to start installation.

➜"PLUG AND PLAY" .... "INSTALL" is displayed, followed by "TUNER" and "AUTO".

➜PROG starts flashing.

➜The system will automatically store the radio stations with sufficient signal strength, starting from FM, and followed by MW band.

➜When all the available radio stations are stored or the memory for 40 presets are used, the first preset radio station will be played.

To reinstall Plug and Play

1In standby mode, press and holdÉÅ on the system until "AUTO INSTALL - PLEASE PRESS PLAY / STOP CANCEL" is displayed.

2Press ÉÅ again to start installation.

➜ All previously stored radio stations will be replaced.

The power-saving feature automatically switches to standby 15 minutes after a CD or tape playback has ended and no control is operated.

Adjusting volume and sound

1Press VOL +/- to adjust volume.

➜ Display shows the volume level VOL and a number from 0-32.

2Press DSC repeatedly to select the desired sound effect: JAZZ / POP / CLASSIC / ROCK.

3Press DBB to switch bass enhancement on or off.

➜ Display shows: if the DBB is activated.

4 Press MUTE on the remote
control to interrupt sound
reproduction instantly.	ALB/
➜ Playback will continue	PRESET
without sound.

●To activate sound reproduction you can:

–press MUTE again;

–adjust the volume controls;

–change source.

12