Philips MRD120 manual Connecting TV, Connections, En gli sh, Option, Using Composite Video jack

Connections

En gli sh

Step 3: Connecting TV

Option 1 Option 2

1

OOFER

MW

OOFER

MW

2 3 2 3 1

IMPORTANT!

–You only need to make one video connection from the following options, depending on the capabilities of your TV.

–Connect the DVD system directly to the TV.

Using Composite Video jack

1Use the supplied composite video cable (yellow) to connect the DVD system’s VIDEO OUT jack to the video input jack (or labelled as A/V In, Video In, CVBS, Composite or Baseband) on the TV.

2To hear the TV channels through this DVD system, use the supplied audio cables (white/red) to connect AUDIO IN-TVjacks to the corresponding AUDIO OUT jacks on the TV.

3 Set the P-SCANswitch to ‘OFF’.

IMPORTANT!

The progressive scan video quality is only possible when using Pr/Cr Pb/CbY, and a progressive scanTV is required.

Using Component Video jack (Pr/Cr Pb /Cb Y)

1Use a component video cables (red/blue/ green - not supplied) to connect the DVD system’s Pr/Cr Pb/CbY jacks to the corresponding Component video input jacks (or labelled as Pr Pb Y or YUV) on the TV.

2To hear the TV channels through this DVD system, use the supplied audio cables (white/red) to connect AUDIO IN-TVjacks to the corresponding AUDIO OUT jacks on the TV.

3If you are using a Progressive Scan TV (TV must indicate Progressive Scan or ProScan capability ), set the P-SCANswitch to ‘ON’. Otherwise, set it to ‘OFF’.

Helpful Hint:

– You have to power off the DVD system or switch to standby mode before changing the P-SCAN switch setting.

8