Clearing Commands
To Clear all Learned Commands under a mode
Clearing learned commands is helpful if, for example, you replace your CD player with another brand or model. If you had learned a feature from your old CD player’s original remote on to this remote (such as RANDOM PLAY), that feature would no longer work for your new CD player. Should you wish to remove or clear one or more “learned” commands, follow the steps below:
1.Press and hold the CODE SEARCH button until the red indicator turns on. Release the CODE SEARCH button.
2.Press and release the button for the mode you want to clear (TV, VCR, etc.). The red indicator blinks off.
3.Press and release the LEARN button TWICE. The red indicator blinks off.
4.Press and release the CODE SEARCH button. The red indicator turns off. All learned Commands under that mode are now cleared.
Master Clear - To Clear all Learned Commands under all modes
1.Press and hold the CODE SEARCH button until the red indicator turns on. Release the CODE SEARCH button.
2.Press and release the LEARN button TWICE. The red indicator blinks off.
3.Press and release the CODE SEARCH button. The red indicator turns off. All Learned commands in the remote are now cleared.
TV/VCR/INPUT
When in TV mode the TV/VCR/INPUT button performs the INPUT source switch function.
When in a mode that has been programmed for VCR the TV/VCR/INPUT button performs the TV/VCR antenna switch function.
When in a mode that has been programmed for Cable the TV/VCR/INPUT button performs the A.B switch function.
When in a mode that has been programmed for SAT the TV/VCR/INPUT button performs the TV/SAT switch function.
When in a mode that has been programmed for DVD the TV/VCR/INPUT button performs the DVD Setup function.
18
IR Extender Feature
The IR extender feature lets you use your remote control to control the A/V product that the Audio/ Video Sender is connected to. E.G., if the Audio/ Video Sender is connected to a DVD Player, or VCR in your living room, and the Audio/Video Receiver is connected to a TV in your bedroom; you can control the DVD Player or VCR while watching the picture from it on the TV in your bedroom. The remote sends Radio Frequency (RF) commands to the Audio/Video Sender (the unit with the thin antenna on it). It receives the RF commands from your remote and converts them to Infrared (IR) commands. You plug the IR extender cable into the jack on the back of the Audio/Video Sender and attach the IR emitters to the front of the DVD Player, or VCR, etc. that you want to control.
1.Plug the IR extender jack on the IR emitter cord into the IR EXT. socket located on the back of the Audio/Video Sender.
2.Place the emitter cord in front of the two devices you want to control (e.g., DVD and VCR).
3.Make sure that the two IR emitters are attached close to the IR sensors on the devices you want to control.
|
| Audio/Video | |
|
| Sender. | |
DVD | VCR |
|
|
|
| LEFT | RIGHT DC 12V |
|
| IR . VIDEO IN | AUDIO IN |
IR emitter | IR emitter | IR extender jack | |
The IR emitter cord lets you control up to two IR devices.
19
