Philips PM435 manual Setup

Setup

Battery Installation

1. On the back of the remote, push down on the tab and lift the cover off.

2. Match the batteries to the + and - marks inside the battery case, then insert 2

AAA Alkaline batteries.

3.Press the battery cover back into place.

Battery Saver

Your remote automatically times out if the buttons are depressed more than 30 seconds. This will save your batteries should your remote get stuck in a place where the buttons remain depressed (e.g., between the sofa cushions).

Code Saver

You will have up to 10 minutes to change the batteries in your remote without losing codes you have programmed. However, do not press any buttons until batteries are installed in the remote. If buttons are pressed without batteries in the remote, all codes will be lost.

4

Power-On Default

The remote powers on in TV mode.

TV Volume/Mute Punch-Through

The TV Volume/Mute punch-through feature lets you control the Volume and Mute function of your TV in any mode programmed to be a VCR, DVD, or SAT device, without needing to change to TV mode.

VCR Punch-Through

Punch-through to VCR mode is only allowed in TV, and VCR modes. SAT is dedicated for satellite mode.

Code Setup

The Code Search button is used to setup the remote. You can either setup the remote using the code for your brand of product, from the code tables, or you can search through the library of codes until you find a code that works for your product.

NOTE: You can store any kind of code under any mode (except TV). I.E. you can store a VCR code under the SAT key, or a DVD code under the VCR key, etc. However, you can only store TV codes under the TV key.

	VCR	DVD
TV			SAT
		CHAN+
CODE			PREV
SEARCH			CHAN
Code Search.		MUTE	VOL
			+
			REPEAT
		CHAN
SLEEP			SUBTITLE
		POWER	CC
	PIP	TOGGLE

5