Philips PRI920CI If your antenna has a Found, Cable 75 ohm on the end, then, Push the round end

A combination antenna receives normal broadcast channels

(VHF 2-13 and UHF 14-69).

	Your connection is easy since
	there is only one 75C_ (ohm)
	antenna plug on the back of your
	TV - and that's where the antenna
	goes.
,_	If your antenna has a Found
	cable (75 ohm) on the end, then
	you're ready to connect it to the TV.
	If your antenna has flat twin-lead
	wire (300 ohm), you first need to
	attach the antenna wires to the screws
	on a 300 to 75 ohm adapter.
	,_ Push the round end of the
	adapter (or antenna) onto the 75_
	plug on the rear of the TV. If the
	round end of the antenna wire is
	threaded, screw it down tight.

Note: For homes with separate UHF and VHF antennas you will need an optionalcombiner to connect to the TV.

u/v

Combiner

Back of TV

75-300 Ohm Adapter

Remember: t Be sure to set the

TV for the type sig- nal you've connect- ed (see the "Tuner" section on page I I of this manual.)

To set the TV to select only the chan- nel numbers in your area see how to

"Program" or "Add" channels in the TV's

memory on page 12 (Auto Program sec- tion).

To order any option- al accessory contact your dealer or the Philips Parts Center at 1-800-851-8885.

Combination VHF/UHF

Antenna

(Outdoor or Indoor)

Back of TV

Round Cable

7512