Philips RU240 manual Batteries, Setting UP by Code Entry, Setting UP by Autosearch

RU240- page 5

SBC RU 240 Instructions for use

BATTERIES

Insert the batteries as indicated in the battery compartment (rear of remote). Only use batteries of type R03, UM4 or AAA. Replace the batteries when required, or at least once a year.

SETTING UP BY CODE ENTRY

Before you set up the SBC RU 240 to operate your equipment, look up the first code for your equipment in the brands list on page 37.

1.Press TV, VCR, SAT or AUX to select the device.

2.Press and hold 1 and 3 at the same time for 3 seconds.

–The indicator LED lights up.

3.Enter the 3-digit code for your brand with the numerical keys.

–The indicator LED blinks twice to indicate successful set-up.

–Press buttons on the SBC RU 240 to check that the code works on your equipment. If it does, write down this code inside the SBC RU 240's battery lid.

–If the equipment does not respond correctly, try the next code from the code list until the equipment works properly.

–If none of the listed codes work, go to Chapter SETTING UP BY AUTOSEARCH

–Repeat steps 1 to 3 for every piece of equipment you want to operate.

SETTING UP BY AUTOSEARCH

Before you start, make sure the equipment is ready to receive infra-red signals. The equipment must be switched on, there should be no obstacles between you and the equipment, and you should be right in front of the equipment. Before setting up a VCR, insert a tape and start Playback.

1.Press TV, VCR, SAT or AUX to select the device.

2.Press and hold 1 and 3 at the same time for 3 seconds.

–The indicator LED lights up.

3.Press Power y to start the search.

–Every time the LED lights, another code is tested. When the right code for your device is found, the equipment (TV or SAT) switches off, or the VCR stops playing. Immediately proceed with step 4.

4.Press Power y twice to lock the code.

–The indicator LED blinks twice to indicate successful set-up.

Notes

–Turn on the equipment again and press the SBC RU 240's buttons to see if they are working as expected. Some codes are quite similar.

If your equipment does not respond correctly, repeat steps 1 to 4 to find a better code.

–Maximum search time is 8 minutes for TV, 4 minutes for VCR and 5 minutes for SAT.

English

5