Philips RU240 Reading OUT the 3-DIGIT Brand Code, Using the AUX Button, Free-Phone Help-Line

RU240- page 6

English

SBC RU 240 Instructions for use

READING OUT THE 3-DIGIT BRAND CODE

After using autosearch to set up the SBC RU 240, note the 3-digit code for future use.

1.Press the button of the device [TV, VCR, SAT or AUX] you want to read the code from.

2.Press and hold 1 and 6 at the same time for 3 seconds.

–The indicator LED lights up.

3.Press -/--;

–The LED indicator goes out.

4.Press 1:

–the indicator starts to blink; Count the number of blinks for the first digit. Note: if the indicator does not blink, the digit is 0.

5.Press 2:

–the indicator starts to blink; Count the number of blinks for the second digit.

6.Press 3:

–the indicator starts to blink; Count the number of blinks for the third digit.

7.Write down the code inside the SBC RU 240's battery lid.

USING THE AUX BUTTON

The AUX button can be used to control a second TV, VCR or SAT receiver. The AUX button is pre-installed for a second video recorder. If you want to operate a second TV instead, proceed as follows:

1.Press and hold 1 and 6 at the same time for 3 seconds.

– The indicator LED lights up.

2.Enter 9,9,2

3.Press TV,

4.Press AUX

–Now follow the procedures in the Chapter SETTING UP BY CODE ENTRY to enter the code for your second TV.

If you want to operate a second SAT receiver with AUX, in step 3 press SAT (instead of TV), and use the SAT code list to find the brand code.

FREE-PHONE HELP-LINE

If you have any problems with your Philips Universal remote control, please ring our free-phone help-line.

United Kingdom: 0800-968-118

Ireland: 1-800-553-136

Before calling, note the data of your equipment in the table below. This makes it easier and faster for us to help you.

Type-numbers can usually be found in the original manual, or on the factory plate on the back of the equipment.

Device	Brand	Model nr.	RC model nr.	Used code
TV

VCR

SAT

AUX

6