Philips SA5211 7. Static characteristics, 8. Dynamic characteristics

Philips Semiconductors SA5211
Transimpedance amplifier (180 MHz)
Product specification Rev. 03 — 07 October 1998 3 of 28
9397 750 07427 © Philips Electronics N.V. 2001. All rights reserved.
7. Static characteristics
[1] Test condition: output quiescent voltage variation is less than 100 mV for 3 mA load current.
8. Dynamic characteristics
Table 3: Recommended operating conditions
Symbol Parameter Conditions Min Max Unit
VCC supply voltage 4.5 5.5 V
Tamb ambient temperature range -40 +85 °C
TJjunction temperature range -40 +105 °C
Table 4: DC electrical characteristics
Min and Max limits apply over operating temperature range at V
CC
= 5 V, unless otherwise specified. Typical data apply at
V
CC
= 5 V and T
amb
=25 ° C.
Symbol Parameter Test conditions Min Typ Max Unit
VIN input bias voltage 0.55 0.8 1.00 V
VO±output bias voltage 2.7 3.4 3.7 V
VOS output offset voltage −0 130 mV
ICC supply current 20 26 31 mA
IOMAX output sink/source current[1] 34−mA
IIN input current
(2% linearity) Test Circuit 8, Procedure 2
±20 ±40 −µA
IIN MAX maximum input current
overload threshold Test Circuit 8, Procedure 4
±30 ±60 −µA
Table 5: AC electrical characteristics
Typical data and Min and Max limits apply at V
CC
= 5 V and T
amb
=25 ° C
Symbol Parameter Test conditions Min Typ Max Unit
RTtransresistance (differential output) DC tested RL = ∞
Test Circuit 8, Procedure 1 21 28 36 kΩ
ROoutput resistance (differential output) DC tested −30 −Ω
RTtransresistance (single-ended output) DC tested
RL = ∞10.5 14 18.0 kΩ
ROoutput resistance (single-ended output) DC tested −15 −Ω
f3dB bandwidth (-3dB) TA = 25°C
Test circuit 1
−180 −MHz
RIN input resistance −200 −Ω
CIN input capacitance −4−pF
∆R/∆V transresistance power supply sensitivity VCC = 5±0.5 V −3.7 −%/V
∆R/∆T transresistance ambient temperature sensitivity ∆Tamb = Tamb MAX-Tamb MIN −0.025 −%/°C
INRMS noise current spectral density (referred to
input) Test Circuit 2 f = 10 MHz
TA = 25 °C
−1.8 −pA/√Hz
ITintegrated RMS noise current over the
bandwidth (referred to input) TA = 25 °C Test Circuit 2
−−−−