![](/images/new-backgrounds/1311715/3117157x1.webp)
English
RU240- page 4
3Immediately press to stop the search.
If you missed the correct code because the search went too far, switch the equipment back on, then press P (down) to send the previous code again. Press P
(down) repeatedly until the equipment switches off again.
4Once you've found the correct code, press to lock it in memory. The green LED blinks twice.
That's it! Now, switch the equipment manually on again, then press a few keys on the remote to check that the equipment responds correctly. In the rare instance that it doesn't, try again from step 1 to find a better code.
Note that code! To save time if you ever need to setup again, make a note of the correct code inside the battery case and in the back of this booklet. In case you have forgotten to note the code you can still 'read out' the code from the remote. Here's how:
1Make sure you've selected the right mode (with ). Then press
and release 1 and 6 at the same time; the green LED lights up.
2Press . The green LED goes out.
3 Press | 1 | and count the number of times the green LED blinks. This |
|
is the first digit of the
zero.) |
|
|
Press | 2 | and count the number of blinks for the second digit. |
Press | 3 | and count the number of blinks for the third digit. |
ADVANCED TIPS AND TRICKS
TO CHANGE AUX MODE TO CONTROL A SECOND TV
The AUX mode on this remote is used to control additional equipment. It is factory preset to control a second VCR, but you can change it to control a second TV, for example.
Before you start, press
TV is switched on.
1 Press and hold 1 and until the green LED lights up.
2On the keypad, enter 992.
3Press to select TV mode, then press any key except
once more. That's it!
Don't forget you now need to setup the remote to operate this second TV - see Getting started.
TO CONTROL THE SECOND TV'S VOLUME
If you have installed a second TV under AUX mode, you can also control that TV's volume when you are in VCR mode.
Before you start, press | to select VCR. |
1 Press and hold 1 and | 6 at the same time until the green LED |
lights up (about 3 seconds).
4