SC360 page 4
1. GENERAL
English
CONTENTS |
| |
1. | GENERAL | 4 |
2. | QUICK REFERENCE | 4 |
3. | POWER SUPPLY | 4 |
4. | OPERATION | 5 |
| TECHNICAL SPECIFICATIONS | 24 |
| ILLUSTRATIONS | 3 |
2. QUICK REFERENCE
INTRODUCTION
Congratulations! You have just purchased a truly cordless Babysitter (SBC SC360) that enables you to monitor your child from wherever you are in and around your house. The Babysitter has been tested to meet all necessary regulations and standards, and features a battery
Note: While the Babysitter is intended as an aid, it is not a replacement for real parent supervision and should not be used as such.
QUICK REFERENCE
1.Connect the enclosed mains adapter to the ‘baby unit’ (transmitter) (fig. 3).
2.Install batteries (not enclosed) inside the ‘parent unit’ (receiver) as indicated in fig. 4.
3.Switch the transmitter on (fig. 1.2) and place it near the baby’s bed.
4.Switch the receiver on to an acceptable sound level (fig. 2.4).
–Every time sound is detected from or near the baby, it is transmitted to the parent’s unit.
5.Adjust the sound level on the receiver as required.
3. POWER SUPPLY
MAINS POWER SUPPLY
•Check that the mains voltage as indicated on the mains adapter corresponds to your local mains voltage. If it does not, consult your dealer or our service organisation.
•Connect the mains adapter to the transmitter as indicated in fig. 3.
BATTERY POWER SUPPLY (batteries not enclosed)
•Install batteries inside receiver as indicated in fig. 4 for cordless receiver operation.
–The receiver can also be connected to a mains adaptor (optional Philips SBC 6650).
Notes
–The receiver has a ‘battery low’ indication. If the batteries are low, the unit beeps and the red power LED starts flashing.
–Remove the batteries from the receiver when they are not going to be used for a long period of time.
–Only use PHILIPS LR6 POWERLIFE batteries.
4
