SC360 page 5
4. OPERATION
OPERATION (fig. 5)
Transmitter
•Make sure the mains power adapter is connected correctly.
•Place the transmitter near the baby’s bed, making sure that the microphone is placed in the best position for picking up baby’s sounds.
IMPORTANT!
Make sure that the transmitter is always out of reach of the baby; never place the transmitter inside baby’s bed or playpen!
•Switch the transmitter on using the POWER switch (fig. 1.2).
–The red POWER LED lights up.
–If sound is picked up by the
Receiver
•Make sure that batteries are installed correctly, or a mains adaptor is connected.
•Switch the receiver on to an acceptable sound
level (fig. 2.4).
–The red POWER LED lights up.
–If a sound signal is received from the transmitter, it is heard via the
• Adjust the sound level as required.
Note
Do not place transmitter and receiver too close to each other while operating. Otherwise the units will start resonating (giving a
IMPORTANT!
Before using the Babysitter, check the sound transmission to ensure that both units function correctly. After this first check, sound transmission should be checked on a regular basis as follows:
•Have an adult softly speak into the transmitter.
–Sounds transmitted from the baby room should be heard clearly via the receiver in another room.
CHANNEL SELECTION
–The Babysitter can use 2 different channels for radio signal transmission. If sound reception is very poor, please try the other transmission channel as follows:
•Move the channel selector on both units to the other channel (fig. 1.1 and fig. 2.3).
Note: Always make sure the channel switches on both units are set to the same position. This ensures optimum reception.
BELT-CLIP
When batteries are installed, the receiver can be used as a truly cordless product. The unit can be carried in and around the house, using the easy
English
5
