Philips SDV8622/12 user manual Connect to the TV, Set up a digital tuner with this antenna

Connect to the TV

Note

•• As previously noted, the amplifier (Power inserter + Power supply) must be placed in- line between the antenna and any splitter or additional devices.

1 Connect the coaxial cable from the antenna to the connector labeled AMP on the power inserter .

2 Connect the power inserter to the antenna input on the TV, digital set-top box, splitter or other devices.

3 Connect the power supply plug to the power inserter , and then plug the power supply adaptor into a 100-240V AC receptacle.

10EN

Warning

•• The power inserter and power supply are for indoor use only.

Tip

•• This antenna includes a 6m roll of 3C-2V coaxial cable. If this is not adequate for your needs, replace the cable with a RG-6 coaxial cable instead of adding an extension.

Set up a digital tuner with this antenna

You can install available channels with the digital TV tuner.This automatic process is part of the setup of the tuner. Ensure the antenna has

set up properly before the tuner can receive viewable channels.

There are two ways to connect the antenna to the TV:

•Connect the antenna to a digital tuner. If the signal strength is good enough, the channels can be memorized in the tuner automatically .

•Connect the antenna directly to the TV.

Tune to the analogue channels and find the best antenna location. Then re- connect the antenna to the digital tuner. Ensure the signal strength is good enough before you install the channels with the tuner.