1Select the adapter plug for yourcountry and slide it over the power plug of the charging cable.OR:Fold out the contact blades.2 Insert the power plug into a wall outlet.3 Turn the protective cap, covering the connectors, to the left.

4 Insert the plug at the other end of the charging cable into the remote control power supply jack.

5If desired, set the On / Off switch to the right (On).The On / Off switch is located at the rear of the remote control.Use a pen or small screwdriver to set the switch.•The Philips Startup screen appears, followed by the Language

Selection screen.The progress animation () in the top right corner of the screen indicates the charging status.

•When the battery is fully charged the battery full icon () appears at the top right corner of the screen.

Notes

•Operation time of a fully charged battery is approximately 1 month but also depends on the intensity of usage.When the battery is almost empty the

battery low icon () flashes in the top right corner of the screen. Recharge the battery as described above.

•When the battery cannot be recharged anymore it needs to be replaced. For this, refer to chapter 7.2.2 ‘Replacing the battery’.

2.2Setting up the remote control

Make sure the remote control is fully charged and turned on (for this refer to chapter 2.1 ‘Charging the battery’).

Avoid turning off the remote control with the On / Off switch at the rear for this will shorten battery life time.

1 Select your preferred language by

Setup

 

touching the language (flag) in the

English

Language Selection screen.

Français

 

Español

 

Deutsch

• Use the and buttons, at the bottom of the screen, to scroll through the list of available languages.

•A welcome message appears.
Getting started English

EN 4