Instructions for use
Manually setting the remote control
1Turn on the TV manually or use the original remote control.Tune in to channel 1.
2Look up the brand of your TV in the code list at
the back of this manual. One or more
On our website www.philips.com/urc you can directly select your device typenumber to find the right code.
English
3Use a pen or paper clip to press the Setup key and
keep it pressed for 5 seconds until the Standby key blinks twice and then remains lit.
4Then enter the code noted in step 2, using the digit keys.
– The Standby key will now blink twice. If the key blinks once for an extended period, the code has not been entered properly or the wrong code has been entered.
Start again from step 2.
5Point the SRU 4010 at the TV and check that it responds as it should.
–If the TV responds to all of the key commands, the SRU 4010 is ready for use. Do not forget to note your code.
•If the device does not respond at all, or not to all of the key commands, start again from step 2 and try the next code from the list.
Automatically setting the remote control
The remote control will now automatically search for the right code for your device.
1Make sure the TV is switched on and select a channel using the original remote control or the keys on the TV (for example channel 1).
2Use a pen or paper clip to press the Setup key and
keep it pressed for 5 seconds until the Standby key blinks twice and then remains lit.
3Press the Standby key of the SRU 4010 and keep it pressed.
–The SRU 4010 now starts emitting all known ‘TV off ’ signals, one by one. Each time a code is sent, the Standby key lights up.
5
