JVC RX-7022VSL manual Try to operate your CATV converter or DBS, tuner by pressing CATV/DBS, Codes

5Try to operate your CATV converter or DBS

tuner by pressing CATV/DBS .

When your CATV converter or DBS tuner turns on or off, you have entered the correct codes.

If there are more than one code listed for your brand of

CATV converter or DBS tuner, try each one until the correct one is entered.

Note:

You cannot use both the CATV converter and DBS tuner at the same

time.

To change the transmittable signals for operating a VCR

1Press and hold VCR .

2Press VCR.

3Enter manufacturer’s codes using buttons 1 – 9, and 0.

4Release VCR .

Now, you can perform the following operations on the VCR.

VCR : Turn on or off the VCR.

Manufacturers’ codes for CATV converter

Manufacturer	Codes
GENERAL INSTRUMENT	06, 07, 08, 09, 10,
	11, 12, 13, 14, 29
HAMLIN/REGAL	01, 02, 03, 04, 05
JERROLD	06, 07, 08, 09, 10,
	11, 12, 13, 14
OAK	15, 16, 17
PANASONIC	18, 19, 20
PIONEER	21, 22
SCIENTIFIC ATLANTA	23, 24, 25
TOCOM	26
ZENITH	27, 28

Manufacturers’ codes are subject to change without notice. If they are changed, this remote control cannot operate the equipment.

Manufacturers’ codes for DBS tuner

Manufacturer	Codes
JVC	56, 57*, 67
AMSTRAD	43, 44, 45, 46, 47
BLAUPUNKT	30
ECHOSTAR	50, 51, 67
GOLDSTAR	31
GRUNDIG	32, 33
HIRSHMANN	48, 52, 53, 55
INSTRUMENT	68
ITT/NOKIA	34
KATHREIN	52, 58, 61, 62, 63
NEC	35, 36
ORBITECH	48
PHILIPS	37, 38
RCA	65
SAMSUNG	39, 40
SCHWAIGER	61, 64
SIEMENS	41, 42
SONY	66
TECHNISAT	48

*“57” is the initial setting.

Manufacturers’ codes are subject to change without notice. If they are changed, this remote control cannot operate the equipment.

After pressing VCR, you can perform the following operations on the VCR:

CH +/–	: Change the channels.
1 – 9, 0, +10 (100+)	: Select the channels.
10	: Function as ENTER button.
3	: Start playback.
FF	: Fast-wind a tape.
REW	: Rewind a tape.
7	: Stop playback or recording.
8	: Pause playback. To release it, press 3.
REC PAUSE	: Press this button to enter recording
	pause.
	Then press 3 to start recording.

Note:

Refer also to the manual supplied with your VCR.

5Try to operate your VCR by pressing

VCR .

When your VCR turns on or off, you have entered the correct codes.

If there are more than one code listed for your brand of

VCR, try each one until the correct one is entered.

TO BE CONTINUED TO THE NEXT PAGE

38