JVC RX-7022VSL manual Using DAP Modes and All Channel Stereo

When you select “PL II MUSIC,” you can go to the following adjustment.

Remote

Using DAP Modes and All Channel Stereo

Once you have adjusted the DAP modes and All Channel Stereo, the

4Turn Panorama control on or off.

1) Press ADJUST repeatedly until “PANORAMA” (with the current setting)* appears on the display.

NOT

ADJUST SETTING

adjustment is memorized for each source.

•You cannot use the DAP modes and All Channel Stereo if no rear speakers are connected.

•You cannot adjust the effect level for “ALL CH STEREO.”

From the remote control:

	SPK 1			TUNED STEREO	AUTOMUTING
DIGITAL AUTO	L	C	R	PROLOGIC ΙΙ DSP H.PHONE INPUT ATT	VOLUME
LINEAR PCM	S.WFR LFE
	LS	S	RS

*“OFF” is the initial setting. If you have already changed the setting, “ON” will be shown.

It will be convenient for you to use the remote control for adjustments, since you can make adjustments from your listening point.

1Start playing 2 channel software—either analog or Linear PCM—and select the source.

2Press SURROUND ON/OFF to activate SURROUND

2) Press CONTROL UP 5/	CONTROL
	DOWN UP

Surround mode.

ON/OFF

DOWN ∞ to turn on or off

Panorama control.

•Each time you press the button, “ON” and “OFF” change alternately.

When the Surround mode turns on, the last selected Surround mode will be activated.

•Each time you press the button, Surround mode turns on and off alternately.

ON	: Select this when you like to enjoy
	“wraparound” sound effect with side-wall
	image.
OFF	: Select this when you like to enjoy
	originally recorded sounds.

To cancel Surround mode

Press SURROUND ON/OFF again so that “SURROUND OFF” appears on the display.

•If Surround mode is canceled while playing back multichannel digital software, all channel signals are mixed and output through the front speakers (and subwoofer if you have connected a subwoofer and set the subwoofer setting correctly—“YES”).

3Press SURROUND MODE repeatedly until one of the DAP modes—“LIVE CLUB,” “DANCE CLUB,” “HALL” and “PAVILION”—or “ALL CH

STEREO” appears on the display.

The DSP indicator also lights up on the display.

If you like to adjust sound, go to step 4.

4Press SOUND.

The 10 keys are activated for sound adjustments.

5Adjust the speaker output levels (–10 to +10).

•To adjust the left rear speaker level, press REAR•L +/–.

•To adjust the right rear speaker level, press REAR•R +/–.

For “ALL CH STEREO” only:

•To adjust the center speaker level, press CENTER +/–.

SURROUND

MODE

SOUND

–REAR• L+

5 6

ENTER

ENTER

–REAR• R+

8 9

–CENTER+

2 3

MENU

6For DAP modes only:

Press EFFECT to select the effect	EFFECT
	1
level (1 to 5) you want.

•Each time you press the button, the effect level changes as follows:

EFFECT 1	EFFECT 2		EFFECT 3
EFFECT 5		EFFECT 4

As the number increases, selected mode becomes stronger (normally set it to “EFFECT 3”).

28