JVC RX-7022VSL Press SURROUND ON/OFF to activate Surround mode, Press ADJUST repeatedly until

SURROUND ON/OFF

Creating Realistic Sound Fields

On the front panel:

1Start playing 2 channel software—either analog or Linear PCM—and select the source.

2 Press SURROUND ON/OFF to activate Surround mode.

When Surround mode turns on, the last selected

Surround mode will be activated.

•Each time you press the button, Surround mode turns on and off alternately.

3Press SURROUND MODE repeatedly SURROUND MODE

until one of the DAP modes—“LIVE CLUB,” “DANCE CLUB,” “HALL”

and “PAVILION”—or “ALL CH STEREO” appears on the display.

The DSP indicator also lights up on the display.

5For DAP modes only: Adjust the effect level.

1) Press ADJUST repeatedly until	ADJUST SETTING
“EFFECT” (with the current
setting)* appears on the display.

*“EFFECT 3” is the initial setting. If you have already changed the setting, another setting will be shown.

2) Press CONTROL UP 5/	DOWN UP
	CONTROL
DOWN ∞ to select the effect
level (1 to 5) you want.

•Each time you press the button, the effect level changes as follows:

EFFECT 1 EFFECT 2 EFFECT 3

EFFECT 5 EFFECT 4

As the number increases, selected mode becomes stronger (normally set it to “EFFECT 3”).

If you like to adjust sound, go to step 4.

4Adjust the speaker output levels.

1) Press ADJUST repeatedly until one	ADJUST SETTING
of the following indications (with
the current setting)* appears on the
display.

REAR L : To adjust the left rear speaker output level (–10 to +10).

REAR R : To adjust the right rear speaker output level (–10 to +10).

CENTER : For “ALL CH STEREO” only—to adjust the center speaker output level

(–10 to +10).

	* “0” is the initial setting. If you have already changed the
	setting, another number (level) will be shown.
2)	Press CONTROL UP 5/	CONTROL
		DOWN UP

DOWN ∞ to adjust the selected speaker output levels.

3)Repeat steps 1) and 2) to adjust the other speaker levels.

To cancel DAP modes and All Channel Stereo

Press SURROUND ON/OFF again so that “SURROUND OFF” appears on the display. The DSP indicator goes off.

29