Selecting the Video Input | Remote | |
Terminal | ||
NOT |
This receiver is equipped with the component video input terminals for the DVD player and DBS tuner, which give you higher picture quality. When you use the component video input terminals for the DVD player and/or DBS tuner, change the video input terminal setting.
Before you start, remember...
There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.
1 Press SETTING repeatedly until |
|
|
ST | SETTING | |
“VIDEO IN DVD ” or “VIDEO IN |
|
|
|
| |
|
| |
|
| |
DBS ” appears on the display. |
|
|
•Select “VIDEO IN DVD” to select the video input terminal for the DVD player and “VIDEO IN DBS” for the DBS tuner.
SPK 1
DIGITAL AUTO L C R
LINEAR PCM
CH-
After 2 seconds, the display changes to show the current setting.
2 Press CONTROL UP 5/DOWN ∞ | CONTROL |
to select the appropriate type of | DOWN UP |
| |
the video input terminal. |
|
•Each time you press the button, the display changes as follows:
| COMPONENT |
| S/C |
|
| ||
| (Component) | ||
|
| ||
COMPONENT : Select this when you connect the DVD | |||
| player or DBS tuner to the component video | ||
| input terminals. | ||
S/C | : Select this when you connect the DVD player | ||
| or DBS tuner to the | ||
| video input terminal. | ||
|
|
|
|
Note:
Without changing the video input terminal setting, you can see the picture through the video input terminals, but cannot use the AV COMPU LINK remote control system correctly (see page 32).
“NO” for the subwoofer, “LARGE” for the front speakers, and “SMALL” for the center and rear speakers are initial settings. To get best possible sound, change the subwoofer and speaker settings to fit your listening conditions.
Setting the Speaker Information 
Remote
NOT
To obtain the best possible sound or effect from Surround modes (see pages 26 to 29), register the following speakers and subwoofer information after all connections are completed.
The followings are items you can set:
•Subwoofer
•Speaker
•Speaker
•Crossover
•Low frequency effect
•Dynamic range
Before you start, remember...
There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.
Subwoofer information
Register whether you have connected a subwoofer or not.
1 Press SETTING repeatedly until |
|
|
| |
ST | SETTING | |||
“SUBWOOFER” (with the current |
|
|
| |
|
|
| ||
|
|
| ||
|
|
| ||
setting)* appears on the display. |
|
|
| |
|
|
|
|
|
| SPK 1 |
|
|
|
| DIGITAL AUTO L C R |
|
|
|
| LINEAR PCM S.WFR LFE |
|
|
|
| CH- |
|
|
|
|
|
|
|
|
*“NO” is the initial setting. If you have already changed the setting, “YES” will be shown.
2 Press CONTROL UP 5/DOWN ∞ to CONTROL
DOWN UP
register whether you have connected a subwoofer or not.
•Each time you press the button, the subwoofer setting alternates between “YES” and “NO.”
YES : Select this when you have connected a subwoofer. You can adjust the subwoofer output level
(see page 20).
NO : Select this when you have not connected or have disconnected a subwoofer.
16
